Whirlpool W10558490A Open washer lid and pull out foam packing ring, Install rear leveling legs

Page 9

ELECTRICAL REQUIREMENTS

INSTALL LEVELING LEGS

REMOVE FOAM PACKING

1. Open washer lid and pull out foam packing ring

The latch under the dryer will keep the lid open. Keep the foam ring and use it when transporting your washer/dryer. This packing material is used to keep the washer drum stable during transport.

To avoid floor damage, set washer/dryer onto cardboard before moving across floor. Move washer/dryer close to its final location. Gently place the washer/dryer on its side, on the cardboard.

1. Install rear leveling legs

Push legs into holes in rear corners until they snap into place. Check adjustability of rear legs by pushing in one leg. The other leg should come out. Check both legs. If they do not move freely, remove legs and repeat this step.

2. Install front leveling legs

Examine the front leveling legs. Find the diamond marking. Screw front legs by hand into the holes in the triangular braces in the front corners. Use wrench to finish turning the legs until the diamond marking is no longer visible. Slowly stand the washer/dryer upright.

9

Image 9

Contents Table of Contents WASHER/DRYER SafetyWASHER/DRYER Safety Installation Requirements Tools needed Optional toolsParts supplied If you have You will need Mobile Home Additional Installation Requirements Recessed area or closet installationMobile home installations require Location RequirementsDimensions DIMENSIONS/CLEARANCESClearances Front View Side View Back ViewFloor standpipe drain system Drain SystemWall standpipe drain system Floor drain systemElectrical Requirements It is your responsibilityElectrical Connection Install rear leveling legs Install front leveling legsOpen washer lid and pull out foam packing ring Electrical Connection Choose electrical connection typeRemove terminal block cover Attach power supply cord Power Supply Cord ConnectionConnect neutral ground wire and neutral wire Connect ground wireDirect Wire Strain Relief Attach direct wire strain relief Direct Wire ConnectionConnect neutral wire Attach direct wire cable to strain reliefWire Direct Wire Connection Prepare your 4-wire cable for direct connectionConnect other wires Optional 3-Wire Connection Prepare your 3-wire cable for direct connectionVenting Requirements VentingOptional exhaust installations Recommended exhaust installationsAlternate installations for close clearances Plan Vent SystemInstall exhaust hood Install Vent SystemSpecial provisions for mobile home installations Connect vent to exhaust hoodRemove drain hose form floor drain installations only Attach drain hose to drain connectorConnect Drain Hose Attach clamp to drain hoseConnect Inlet Hoses Check for leaks Connect vent to exhaust outlet Connect Inlet Hoses Connect VentSecure drain hose Laundry Tub Standpipe WallLevel WASHER/DRYER Adjust leveling legsCheck levelness of washer/dryer Plug into a grounded 3- or 4-prong outletIf the dryer will not start, check the following Complete Installation ChecklistPage TM 2013 Whirlpool. All rights reserved