Frigidaire 137111500B Grounding requirements Gas dryer USA and Canada, Gas connection

Page 10

Grounding requirements - Gas dryer (USA and Canada)

1.The dryer is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.

2.The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. If in doubt, call a licensed electrician.

DO NOT cut or remove ground prong from the plug.

Grounding type wall receptacle

Do not, under

any circumstances, cut, remove,

or bypass the grounding prong.

Power cord with

3-prong grounded plug

Gas connection

1.Remove the shipping cap from gas pipe at the rear of the dryer.

DO NOT connect the dryer to L.P. gas service without converting the gas valve. An L.P. conversion kit must be installed by a qualified gas technician.

2.Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.96 cm) pipe located on the back of the dryer. Use a 1/2 inch to 3/8 inch (1.27 cm to 0.96 cm) reducer for the connection. Apply an approved thread sealer that is resistant to the corrosive action of liquefied gases on all pipe connections.

Manual

Flare

GAS FLOW

Shutoff

Flare

Union

Union

 

Valve

 

 

 

 

 

 

 

 

 

 

 

 

 

Closed

Nipple

Flexible

Inlet Pipe on

Open

Connector

Back of Dryer

All connections must be wrench-tightened

The supply line must be equipped with an ap- proved manual shutoff valve. This valve should be located in the same room as the dryer and should be in a location that allows ease of opening and closing. Do not block access to the gas shutoff valve.

3.Open the shutoff valve in the gas supply line to allow gas to flow through the pipe. Wait a few minutes for gas to move through the gas line.

to dryer

from

gas

supply

 

 

 

Shutoff Valve -

Open position

4.Check for gas system leaks with a manometer. If a manometer is not available, test all connections by brushing on a soapy water solution.

- EXPLOSION HAZARD - NEVER test for gas leaks with an open flame.

10

Image 10
Contents Installation Instructions Table of Contents Electrical requirements for electric dryer Electrical requirements for gas dryerGas supply requirements Exhaust system requirementsExhaust system requirements Manufactured or mobile home installation Exhaust directionDo not Install Your Dryer Clearance requirementsInstalled dryer dimensions Grounding requirements Electric dryer USA Electrical installationGrounding requirements Electric dryer Canada Grounding requirements Gas dryer USA and Canada Gas connectionElectrical connection non-Canada 3 wire cord Turn off power supply to outletElectrical connection non-Canada 4 wire cord General installation Window Door Reversal Instructions Page Accessories Replacement parts 1-800-944-9044 in CanadaÍndice Requisitos eléctricos de la secadora eléctrica Requisitos eléctricos de la secadora a gasRequerimientos del suministro de gas Requisitos del sistema de escapeRequisitos del sistema de escape continuación Longitud MáximaInstalación en una casa rodante Dirección del escapeRequisitos de despeje No Instale LA SecadoraDimensiones de la secadora instalada Instalación eléctrica Requisitos de conexión a tierra secadora eléctrica CanadáConexión de gas Flujo DE GASConexión eléctrica fuera de Canadá trifilar Tornillo VerdeConexión eléctrica fuera de Canadá tetrafilar Instalación general Conecte el tubo de escape al sistema de escape exteriorPage Page Accesorios Piezas de repuesto 1-800-944-9044 en Canada