Kenmore 110.9587, 110.9586 manual Installation clearances, Dryer Dimensions

Page 7

•A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part No. 279810.) Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

•For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need an additional 6" (15.24 cm).

Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer.

Installation clearances

The location must be large enough to fully open the dryer door.

Dryer Dimensions

501/="

128.27 cm)

*Most installations require a minimum 51_''(14 cm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements."

Minimum installation spacing for recessed area, custom undercounter or closet installation

The dimensions shown following are for the minimum spacing allowed.

•Additional spacing should be considered for ease of installation and servicing.

•Additional clearances might be required for wall, door and floor moldings.

•Additional spacing of 1" (2.5 cm) on all sides of the dryer is recommended to reduce noise transfer.

For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

•Companion appliance spacing should also be considered.

Custom undercounter installation - Dryer only

0"

0"

27"

0"

 

Closet installation - Dryer only

 

 

 

 

 

3 _,

 

 

(7.6

cm)

10 cm2)

 

 

 

48 in?

 

 

 

LI(124 ions2)

 

3

_,

 

(7.6

cm)

Io"l< 31,/o"_o"I

 

 

 

(O cm) (80 cm) (O cm)

 

 

 

A

 

B

 

A. Side view - closet or confined area

B. Closet door with vents

Recessed or closet installation - Dryer on pedestal

olo

14" max, _-

 

v

O"_

q{-_ 27"

_O"

 

10"t<- al,/2">-I 0"

(O cm)

(68.6

cm)

(0 cm)

(O cm) (80 crn) (0 cm)

 

A

 

B

A, Recessed area

B. Side view - closet or confined area

Mobile home - additional installation requirements

This dryer is suitable for mobile home installations.

The installation must conform to the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280).

Mobile home installations require:

•Metal exhaust system hardware which is available for purchase from your local Sears store or Sears Service Center.

•Mobile home Installation Kit Part Number 346764. See "Tools and Parts" section for ordering information.

•Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening.

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 8562130 Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.ATable of Contents Full One-Year Warranty on Mechanical Parts Full ONE-YEAR Warranty on Mechanical and Electrical PartsWarranty Restriction Warranty ServiceYour safety and the safety of others are very important Dryer SafetySafety Instructions Parts supplied Installation InstructionsDryer Dimensions Installation clearancesLocation must be large enough to fully open the dryer door 2IPS pipe is recommended Gas supply lineDryer gas pipe Gas supply pressure testingElevations above 10,000 ft 3,048 meters Optional exhaust installations Typical exhaust installationsAlternate installations for close clearances Hoods Or elbows Rigid Metal Special provisions for mobile home installationsVent Length Chart Number Type Box or Angled Turns Determine Vent LengfiMake Gas Oo s ecsL Reverse the hinge and hinge cover Remove the doorReverse the door handle Reinstalling the doorIf the dryer will not start, check the following To use an Auto Dry Cycle Dryer USETo make changes during an Auto Dry Cycle Cycle tips Dry most loads using the preset cycle settingsUsethis cycle to get medium high heat for drying denims Control Locked light glows when this option is enabledControl Locked JeansNormal DampdrysignalHeavy Duty BULKY/BEDDINGAir Dry When using Air DryChanging Cycles after pressing Start Dryer Care Rack Drying Setting TimeTo clean As needed cleaningFrom the Exhaust Vent To clean dryer drumMoving care From Inside the Dryer CabinetOdors Page Seguridad ProteccionInstrucciones Mecanicas Y Componentes Electricos Garantlade LA Opcion DE PedestalSu seguridad y la seguridad de los demds es muy importante Seguridad DE LA SecadoraInstrucciones Importantes DE Seguridad Piezas suministradas Instrucciones DE InstalacionPiezas para adquirir Pulg,2 Dimensiones de la secadoraEspacios para la Instalacibn Instalacibn en el clbset Sblo secadoraLas instalaciones en casas rodantes necesitan Instrucciones Para LA Conexion a TierraRequisitos para la conexi6n del suministro de gas Tipo de gas Gas naturalLa linea de suministro de gas Se recomienda un tubo IPS de 1/2Prueba de presibn del suministro de gas El tubo de gas de la secadora15,9cmJ Elevaciones encima de los 10.000 pies 3.048 metrosInstalaciones opcionales de escape Instalaciones tipicas de escapeMe!or3Jbien Lculo de la Iongitud del ducto de escapeCaja o tipo Persianas Codos Para su use en casas rodantes Desmontaje de la puerta Inversibn de la manija de la puerta Inversibn de la bisagra y de la tapa de la bisagraReinstalacibn de la puerta Si la secadora no funciona, revise Io siguiente USO DE LA Secadora Para hacer una pausa de la secadora en cualquier momento Presione PAUSE/CANCELdos veces o abra la puertaAbra la puerta o presione PAUSE/CANCEL unavez Para detener su secadora en cualquier momentoClothesdry Cycl Ccos de secsdo a 4o itcoCsssas aes ManualTouch DRY TMWrinkleguard Cambio de ciclos despuGs de presionar puesta en marcha Sehal de fin de ciclo End of Cycle Signal¢i@09i OIl!S y Cuando use el secado con aireImportante Solucion DE Problemas Se ha separado debidamente la carga? Es la carga muy grande y pesada para secar con rapidez?La secadora no funciona Revise Io siguiente Pelusa en la ropa EetA obstruido el filtro de pelusa?Sears

110.9587, 110.9586 specifications

The Kenmore 110.9586 and 110.9587 models represent a significant contribution to the realm of home laundry appliances, allowing homeowners to experience cutting-edge technology and dependable performance. These washing machines are designed with a focus on efficiency, versatility, and user-friendliness.

One of the standout features of both models is their capacity. With a generous drum size, these washers can accommodate large loads, enabling users to clean more clothes in a single cycle. This feature not only saves time but also energy, as it reduces the number of loads required to complete laundry tasks.

In terms of wash cycles, the Kenmore 110.9586 and 110.9587 offer a wide range of options tailored to meet diverse fabric care needs. This includes specialized cycles for delicate items, heavy-duty fabrics, and even quick wash programs for those in a rush. The inclusion of a soil sensor helps to optimize the wash duration by detecting how soiled the clothes are, thereby ensuring effective cleaning while conserving water and energy.

Energy efficiency is a hallmark of these models. Both the 110.9586 and 110.9587 have been designed to meet or exceed Energy Star standards, making them environmentally friendly choices for the eco-conscious consumer. This not only benefits the environment but also results in lower utility bills, providing long-term savings for homeowners.

Another critical aspect of these washers is their advanced technology. The use of direct drive motors enhances reliability and reduces noise, creating a quieter laundry experience. Additionally, the models come with intuitive digital controls that simplify operation, allowing users to easily select their preferred wash settings.

Durability is another attribute that sets the Kenmore 110.9586 and 110.9587 apart from competitors in the market. Built with robust materials and engineering excellence, these washing machines are designed to withstand the demands of everyday use, ensuring longevity and less frequent repairs.

Overall, the Kenmore 110.9586 and 110.9587 washing machines stand out due to their impressive capacity, extensive wash options, energy efficiency, advanced technology, and durable construction. They provide a reliable, efficient, and convenient laundry solution, making them an ideal choice for families and individuals alike. With these models, users can experience the perfect blend of performance and practicality in their laundry routines.
Top Page Image Contents