Kenmore 110.9586, 110.9587 manual Cycle tips, Dry most loads using the preset cycle settings

4.(OPTIONAL STEP) If desired, select OPTIONS. For more details, see "Options."

5.(OPTIONAL STEP) If desired, set the END of CYCLE SIGNAL. Select HIGH or LOW to alert you when a cycle ends.

6.Press and hold START for approximately 3 seconds until dryer starts. Be sure the door is closed.

•If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off.

•If you wish to end your drying cycle after pressing Start, press PAUSE/CANCEL twice.

g; O %lel"

To stop your dryer at any time

Press PAUSE/CANCEL twice or open the deer.

To pause the dryer at any time

Open the door or press PAUSE/CANCEL once.

To restart the dryer

Close the door. Press and hold START until dryer starts.

NOTE: Drying will continue from where the cycle was interrupted if you close the door and press Start within 5 minutes. If the cycle is interrupted for more than 5 minutes, the dryer will shut off.

Select new cycle settings before restarting the dryer.

This feature allows you to lock your settings to prevent unintended use of the dryer. You can also use the Control Locked feature to prevent unintended cycle or option changes during dryer operation.

To enable the Control Locked feature:

Press and hold AUTO DRY LEVEL for 3 seconds. Control Locked glows and a single beep tone is heard. To unlock, press and hold AUTO DRY LEVEL for 3 seconds. The indicator light turns off.

Properly loading your dryer can lower your utility bill and prolong the life of your garments.

Loading suggestions

•Load the dryer by the amount of space items take up, not by their weight.

•Do not overload the dryer. This causes uneven drying and wrinkling.

Super Capacity	Dryers
Heavy Work Clothes
4 jeans		2 sweatpants
4 workpants		2 sweatshirts
4 workshirts
Towels
10 bath towels		14 washcloths
10 hand towels
Mixed Load
3 sheets (1 king,	2 twin)	9 T-shirts
4 pillowcases		9 shorts
3 shirts		10 handkerchiefs

3 blouses

Select the correct cycle and dryness level or temperature for your

load. If an Auto Dry Cycle is running, the display shows the estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Manual Cycle is running, the display shows the exact number of minutes remaining in the cycle.

Cool Down tumbles the load without heat during the last few

minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level.

Drying tips

•Follow care label directions when they are available.

•If desired, add a fabric softener sheet. Follow package instructions.

•To reduce wrinkling, remove the load from the dryer as soon

as tumbling stops. This is especially important for permanent press, knits, and synthetic fabrics.

•Avoid drying heavy work clothes together with lighter fabrics. This could cause overdrying of lighter fabrics and lead to increased shrinkage or wrinkling.

Cycle tips

•Dry most loads using the preset cycle settings,

•Refer to the Auto Dry or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various loads.

Drying temperature and Auto Dry Level are preset when you choose an Auto Dry Cycle. You can select a different dryness level, depending on your load, by pressing Auto Dry Level and choosing More or Less.

If you wish to adjust the cycle length of a Manual Cycle, press More Time or Less Time. Adjust the temperature of a Manual Cycle by pressing Temperature until the desired temperature is selected.

NOTE: You cannot choose an Auto Dry Level with Manual Cycles.

16