American Dryer Corp ML-75V Starting a Cycle When Computer is in F.S.S. is Disabled Mode

F.S.S. DIAGNOSTICS MESSAGES

OPEN THERMISTOR PROBE – This message indicates that the F.S.S. thermistor probe either is not connected or is damaged. If this condition is detected, the Phase 7 non-coin control will immediately enter F.S.S. DISABLED mode.

SHORTED THERMISTOR PROBE – This message indicates that the F.S.S. thermistor probe is damaged or the wiring is shorted. If this condition is detected, the Phase 7 non-coin control will immediately enter F.S.S. DISABLED mode.

DISCONNECTED WATER VALVE – This message indicates that the water valve is open or that it is not connected to the control. If this condition is detected, the Phase 7 non-coin control will continue to monitor the condition for a period of 5 minutes before entering F.S.S. DISABLED mode. Once the condition is corrected, the control will continue to monitor the condition for 1 minute before exiting F.S.S. DISABLED mode.

SHORTED WATER VALVE – This message indicates that the water valve is shorted or that the wiring to the valve is shorted. If this condition is detected, the Phase 7 non-coin control will continue to monitor the condition for a period of 5 minutes before entering F.S.S. DISABLED mode. Once the condition is corrected, the control will continue to monitor the condition for 1 minute before exiting F.S.S. DISABLED mode.

WATER NOT CONNECTED – This indicates that there is no water pressure at the water valve. This will occur if water is not connected to the dryer, or if there is low water pressure in the water line coming to the dryer. This could also signify a defective pressure switch or defective wiring to the pressure switch. If this condition is detected, the Phase 7 non-coin control will continue to monitor the condition for a period of 5 minutes before entering F.S.S. DISABLED mode. Once the condition is corrected, the control will continue to monitor the condition for 1 minute before exiting F.S.S. DISABLED mode.

STARTING A CYCLE

WHEN COMPUTER IS IN “F.S.S. IS DISABLED” MODE

NON-COIN – When the F.S.S. is disabled, the user can still start a cycle. However, when a cycle is started, the control will display the following message: “F.S.S. IS DISABLED. PRESS ‘START’ TO CONTINUE.” This message will be displayed every time a cycle is started, until the disabling condition has been corrected.

COIN – When the F.S.S. is disabled, the user can still start a cycle. Simply insert credit and select a cycle to start.

53