American Dryer Corp installation manual ML-130 III / ML-130DR Installation Manual

Page 1

ML-130 III / ML-130DR Installation Manual

Phase 7 / HSI and DSI / Dual Timer / F.S.S.

WARNING: For your safety the information in this manual must be followed to minimize the risk of fire or explosion and to prevent property damage, personal injury or death.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

AVERTISSEMENT: Assurez-vous de bien suivre les instructions données dans cette notice pour réduire au minimum le risque d’incendie ou d’explosion ou pour éviter tout dommage matériel, toute blessure ou la mort.

Ne pas entreposer ni utiliser d’essence ni d’autres vapeurs ou liquides inflammables à proximité de cet appareil ou de tout autre appareil.

QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:

Ne pas tenter d’allumer d’appareils.

Ne touchez à aucun interrupteur. Ne pas vous servir des téléphones se trouvant dans le bâtiment.

Évacuez la pièce, le bâtiment ou la zone.

Appelez immédiatement votre fournisseur de gaz depuis un voisin. Suivez les instructions du fournisseur.

Si vous ne pouvez rejoindre le fournisseur de gaz, appelez le service des incendies.

L’installation et l’entretien doivent être assurés par un installateur ou un service d’entretien qualifié ou par le fournisseur de gaz.

American Dryer Corporation

88 Currant Road

Fall River MA 02720-4781 USA

Telephone: +1 (508) 678-9000 / Fax: +1 (508) 678-9447

e-mail: techsupport@amdry.com

www.amdry.com

ADC Part No. 113335-12

Image 1
Contents American Dryer Corporation ML-130 III / ML-130DR Installation ManualDate of Purchase Model no RESELLER’S Name Serial Numbers Retain This Manual in a Safe Place for Future ReferenceTable of Contents What To Do If You Smell Gas Safety PrecautionsPersonal injury or fire could result 113335 Electric ML-130 SpecificationsML-130 Specifications ML-130DR Specifications ML-130DR Specifications Unpacking/Setting Up Installation ProceduresLocation Requirements Leveling DryerTo Remove Top Console Module Dryer Enclosure RequirementsExhaust Transition Piece Gas and Electric Only Exhaust Requirements Fresh Air Supply RequirementsGeneral Exhaust Ductwork Information Single Dryer Venting Outside Ductwork ProtectionML-130 Multiple Dryer Common VentingElectrical Information Electrical Service SpecificationsML-130DR Multiple Dryer Venting Electrical RequirementsGas Model and Steam Model Dryers Electrical ConnectionsElectric Model Dryers Grounding Gas InformationGas Supply Fire or explosion could resultML-130DR ML-130Steam Information Installation InstructionsSteam Coil pH Level Steam Requirements, High PressureAir Requirements Compressed Air Supply Air Pressure Steam Damper Air System ConnectionsAir Connection Steam Damper System OperationPreoperational Test Preparation for OperationHeat Circuit Operational Test Gas Models Electric ModelsOperating Instructions Shutdown InstructionsWarranty Information Service/Parts InformationRoutine Maintenance Data Label Information Reversing Timer Spin/Dwell AdjustmentsLubrication Microprocessor Controller Computer Board Procedure for Functional Check Replacement ComponentsFor Models with DSI Module Type Fire Suppression System Manual Reset Burner Hi-Limit InstructionsTypical water supply Optional Manual Bypass ADC Part No 12 07/31/08