American Dryer Corp ML-130DR Typical water supply Optional Manual Bypass, Electrical Requirements

Page 27

Typical water supply...

Optional Manual Bypass

Provisions are made in the dryer F.S.S. for the installation of an optional manual bypass. Depending on the model dryer, the connections for the manual bypass are made at the “T” or “three way” fitting located in the outlet supply side of the water solenoid valve. The use and connections of this manual bypass are at the option or discretion of the owner.

The water connection for the manual bypass is made to the “T” or “three way” fitting, which has a 3/8” F.P.T. and a coupling must be used to provide the minimum 1/2” supply (feed) line.

If the rear area of the dryer, or the water supply is located in an area where it will be exposed to cold/freezing temperatures, provisions must be made to protect these water lines from freezing.

! WARNING

If the water in the supply line or water solenoid valve freezes, the F.S.S. will be inoperative!!

The manual ball cock shutoff valve must be located outside of the dryer at a distance from the dryer where it is easily accessible.

Electrical Requirements

No independent external power source or supply connection is necessary. The 24 volt power to operate the F.S.S. is accomplished internally in the dryer (from the dryer controls).

! WARNING

Electrical power must be provided to the dryer at all times. If the main electrical power supply to the dryer is disconnected, the F.S.S. is inoperative!!

Notes ______________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

____________________________________________________________

113335 - 12

www.amdry.com

27

Image 27
Contents American Dryer Corporation ML-130 III / ML-130DR Installation ManualDate of Purchase Model no RESELLER’S Name Serial Numbers Retain This Manual in a Safe Place for Future ReferenceTable of Contents Safety Precautions What To Do If You Smell GasPersonal injury or fire could result 113335 Electric ML-130 SpecificationsML-130 Specifications ML-130DR Specifications ML-130DR Specifications Leveling Dryer Installation ProceduresUnpacking/Setting Up Location RequirementsDryer Enclosure Requirements To Remove Top Console ModuleExhaust Transition Piece Gas and Electric Only Fresh Air Supply Requirements Exhaust RequirementsGeneral Exhaust Ductwork Information Multiple Dryer Common Venting Outside Ductwork ProtectionSingle Dryer Venting ML-130Electrical Requirements Electrical Service SpecificationsElectrical Information ML-130DR Multiple Dryer VentingElectrical Connections Gas Model and Steam Model DryersElectric Model Dryers Fire or explosion could result Gas InformationGrounding Gas SupplyML-130DR ML-130Steam Requirements, High Pressure Installation InstructionsSteam Information Steam Coil pH LevelSteam Damper System Operation Steam Damper Air System ConnectionsAir Requirements Compressed Air Supply Air Pressure Air ConnectionElectric Models Preparation for OperationPreoperational Test Heat Circuit Operational Test Gas ModelsOperating Instructions Shutdown InstructionsWarranty Information Service/Parts InformationRoutine Maintenance Reversing Timer Spin/Dwell Adjustments Data Label InformationLubrication Procedure for Functional Check Replacement Components Microprocessor Controller Computer BoardFor Models with DSI Module Type Fire Suppression System Manual Reset Burner Hi-Limit InstructionsTypical water supply Optional Manual Bypass ADC Part No 12 07/31/08