Wide Screen Operation with Computer Signals
Switch to the wide screen mode to expand the 4 : 3 image to fill the entire screen.
1.Press the WIDE button on the remote control.
2.Within 3 seconds ...
Press the WIDE button again.
The screen size switches as follows:
→ NORMAL → FULL → ZOOM
When displaying enhanced split screen:
NORMAL ↔ FULL
NORMAL size screen (4:3 or SXGA 5:4)
The picture has the same size as the normal computer image.
FULL size screen
The image is expanded in the horizontal direction.
ZOOM size screen
When wide signals are input.
FULL size screen
When “PICTURE SIZE” is set to “OFF”
* This cannot be set in some models. “TRUE” size will not be displayed in such cases.
The screen size switches as follows:
→TRUE → FULL → ZOOM
TRUE size screen (VGA, SVGA 4:3)
The image is true resolution.
FULL size screen
The image is expanded in the horizontal and vertical direction.
ZOOM size screen
When wide signals are input.
TRUE
The image is true resolution.
FULL
Information
Supported resolution
See page
“PICTURE SIZE” setting
When the setting of “PICTURE SIZE” is OFF, the size of
NORMAL.
When 852 (848) dot 480 line wide VGA* signals with a vertical frequency of 60 Hz and horizontal frequency of 31.7 (31.0) kHz are in- put
Select an appropriate setting for RGB SELECT mode referring to the“Table of Signals Supported” on page
*“VGA”, “SVGA” and “SXGA” are registered trademarks of IBM, Inc. of the United States.
Note:
Do not allow 4:3 content to be displayed for extended periods of time without using gray bars. This can cause image retention.
Downloaded From |