MicroNet Technology
MN100
manual
Mn100
Specs
Install
Parts list
Audible Signals and Alarms
Maintenance and Fault Finding
Warranty
Maintenance
Setup Page Description
Safety
External Power Connections
Page 1
mn100
Dual Digital Display
uu037 rev. 8
Page 1
Page 2
Image 1
Page 1
Page 2
Contents
Mn100
EMC Conformance
Installation
Setup and Calibration
Maintenance and Fault Finding
Information
Power Management and Battery Life
Specifications
Introduction
Instrument Display Information
Safety and Disposal
Applying External Power
Introduction
Backlighting
Switching the System On and Off
Audible Signals and Alarms
Chapter and Page Operation
Page
Chapters
Chapter and Page Descriptions
Pages
Page
Page
XTE
Time
Current heading is 277 Current speed is 9.56 kts
This page left intentionally blank
Chapter and Page Setup and Calibration
Entering Setup and Calibration Mode
Editing Values
Memory Chapter
Setup Page Description
Units Chapter
Alarms Chapter
Speed Chapter
Calibration Page Description
Depth Chapter
Compass Chapter
Wind Chapter
Options Chapter
Health Chapter
Depth Offset
To enter a Log Calibration Factor
Speed Calibration
Wind Angle Offset
Wind Calibration
Wind Speed Correction
Compass Calibration
Precautions and Positioning Advice
Tools Required Parts List
Bracket Mounting Preferred Method
Temporary Mounting
External Power Connections
Fault Finding and Technical Support
Care and Maintenance
Maintenance and Fault Finding
No Nmea data showing on external instruments
Warranty Information
Related pages
What should I do if I need to replace parts for my Komatsu Zenoah strimmer?
Top
Page
Image
Contents
