mn100 Dual Digital Display
5.4Surface Mounting
5.4.1Where there is no access to the rear of the mounting surface
Easy installation but will allow removal without gaining access to the boat. Position the supplied Template carefully before starting.
1.Drill three 2mm holes marked “SURFACE” on the Template
2.Carefully snap the facia of the instrument off the main body taking care not to drop the button pads. .
HINT – It may be useful to place a piece of sticky tape across the front of the buttons before removing the facia to prevent them from falling out during the installation.
3.Remove the three captive M4 nuts from the plastic moulding and attach the instrument to the mounting surface using the three self tapping screws provided. Take care not to over tighten the screws as this may cause the moulding to crack.
4.Check the instrument is perfectly level, carefully position the button inserts into the correct slots and snap the facia back into position.
5.4.2 Temporary Mounting
1.Use the double sided tape provided to secure the instrument to a suitable mounting surface. Press the instrument firmly
against the surface until secure.
Note: This method is recommended for temporary use only.
32