MicroNet Technology MN100 manual Instrument Display Information

Page 5

Operation

2 – Operation

Important:

Ensure that the “Auto Network” procedure described on the yellow instruction sheet and full Setup and Calibration has been performed correctly before attempting to use your Micronet instruments for navigation purposes.

2.1Instrument Display Information

Image 5

Contents Mn100 EMC Conformance Installation Setup and CalibrationMaintenance and Fault Finding InformationIntroduction SpecificationsPower Management and Battery Life Instrument Display Information Safety and Disposal Applying External PowerIntroduction Backlighting Switching the System On and OffAudible Signals and Alarms Chapter and Page Operation Page Chapters Chapter and Page DescriptionsPages Page Page XTE Time Current heading is 277 Current speed is 9.56 kts This page left intentionally blank Chapter and Page Setup and Calibration Entering Setup and Calibration ModeEditing Values Units Chapter Setup Page DescriptionMemory Chapter Alarms Chapter Depth Chapter Calibration Page DescriptionSpeed Chapter Compass Chapter Wind ChapterOptions Chapter Health Chapter Depth Offset To enter a Log Calibration Factor Speed CalibrationWind Speed Correction Wind CalibrationWind Angle Offset Compass Calibration Precautions and Positioning Advice Tools Required Parts ListBracket Mounting Preferred Method Temporary Mounting External Power Connections Fault Finding and Technical Support Care and MaintenanceMaintenance and Fault Finding No Nmea data showing on external instruments Warranty Information