English |
§Standard or second velocity characteristics
§Shunting gear active or inactive
§Fast, medium or slow acceleration and brake delay
The setting of the delay can be combined with any setting of the velocity characteristic and the shunting gear.
The setting is made by attaching solder bridges to X17 (on the front of the decoder, underneath the IC U1) and to X20 (on the front of the decoder, to the left of IC U1). The assignment is as follows:
Connection | Operation |
|
|
| ||
X17 | Pin 1: no solder bridge | Standard velocity characteristic + | ||||
|
|
| shunting gear active, switched via F4 | |||
X17 | Pin 1 | - X 20 | Second velocity characteristic + | |||
|
|
| shunting gear inactive |
| ||
X17 | Pin 1 | - X 17 Pin 2 | Standard velocity characteristic + | |||
|
|
| shunting gear inactive |
| ||
X17 | Pin 3: no solder bridge | Fast delay |
|
|
| |
X17 | Pin 3 | - X 20 | Slow delay |
|
|
|
X17 | Pin 3 | - X 17 Pin 2 | Medium delay |
|
|
|
|
|
| Example: |
|
|
|
|
|
| Adjusting | the | second | velocity |
|
|
| characteristic | and | the | medium |
|
|
| acceleration and brake delay |
| ||
Setting the locomotive address
The locomotive decoder can be set to one of 255 addresses. The setting is made by mounting solder bridges to X13 - X17 (on the front of the decoder, left of the IC U1) resp. X18 on the front of the decoder, right of the IC U1). The assignment is shown in the list on page 68.
The solder pads are numbered from the left side of the PCB as follows:
1
2
3
Page 31