Motorola LD-W-1 manual Fire risk, Thermal danger, Other dangers

Page 6

LD-G-1 / LD-W-1

English

Fire risk

Touching flammable material with a hot soldering iron can cause life- threatening fire, burns and toxic smoke. Connect your soldering iron or soldering station only when actually needed. Use the correct soldering iron or station and never leave a hot soldering iron or station unattended.

Thermal danger

A hot soldering iron or liquid solder accidentally touching your skin can cause skin burns. As a precaution:

§use a heat-resistant mat during soldering,

§always put the hot soldering iron in the soldering iron stand,

§point the soldering iron tip carefully when soldering, and

§remove liquid solder with a thick wet rag or wet sponge.

Dangerous environments

A working area that is too small or cramped is unsuitable and can cause accidents, fires and injury. Prevent this by working in a clean, dry room with enough freedom of movement.

Other dangers

Children can cause any of the accidents mentioned above because they are inattentive and not responsible enough. Children under the age of 14 should not be allowed to work with this kit or the ready-built module.

Little children can swallow small components with sharp edges. Life threatening! Do not allow components to reach small children.

In schools, training centres, clubs and workshops, assembly must be supervised by qualified personnel.

In industrial institutions, health and safety regulations applying to electronic work must be adhered to.

Page 23

Image 6
Contents LD-G-1n Anleitung Nederlands 07/2002 Tams Elektronik GmbHTable of contents How to use this manual Intended useSafety instructions Mechanical hazardsElectrical hazards Fire risk Thermal dangerOther dangers EMC declaration Information Motorola I and Motorola II formatOperation overview Technical specifications Checking the package contentsRequired tools and consumables Safe and correct solderingConnecting the lighting and other accessories Connecting the LD-G-1Connecting the LD-W-1 Performing a visual checkConnecting the LEDs Setting the locomotive decoder Using an NEM 652 interface connectorSetting the driving characteristics Setting the locomotive address Improvement of the driving characteristics Emergency stop during active acceleration and brake delaySwitching the shunting gear OperationFAQ Manufacturers noteConditional warranty CertificationAdresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1 / LD-W-1 Adresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1LD-G-1 LD-W-1 LD-G-1 / LD-W-1 LD-G-1 / LD-W-1 Tams Elektronik GmbH