Motorola LD-W-1 manual Operation, Emergency stop during active acceleration and brake delay

Page 15

English

LD-G-1 / LD-W-1

The solder pad "4" is identical with connecting point X18. If for one address two connections to solder pad 4 are given, two connections to point X18 must be made.

!Caution:

Use a soldering iron with a small tapered point and max. 30 Watt to make the solder bridges. Take special care to avoid short circuits. If necessary, check the solder bridges with a magnifiying glass to make sure that the solder bridges are closed correctly and solder has not short-circuited adjacent components or connections.

Operation

Emergency stop during active acceleration and brake delay

An emergency stop during acceleration and brake delay can be performed from the central unit by changing the direction of travel.

Switching the shunting gear

The solder bride X17 is used for switching the shunting gear. When activated the aproach and braking delays are automatically deactivated. The other accessories connected to the output X10 will also switch with the shunting gear.

Improvement of the driving characteristics

Locomotives with especially high current consumption or track sections with bad contacts (e.g. some types of points) may give an unsatisfactory performance after the mounting of the locomotive decoder. You can improve the locomotive performance by soldering a capacitor 220 µF / > 25 V in parallel to the capacitor C2 (rear of the locomotive decoder, see fig. 4 or 5).

The settings cannot be saved by the decoder and are lost after a power supply interruption of a certain length. When the interruption is only short, the capacitor C1 maintains the voltage and the settings are kept. You can lengthen this period of time by soldering a capacitor 47 µF / > 6,3 V in parallel to the capacitor C1 (rear of the locomotive decoder, see fig. 4 or 5).

Page 32

Image 15
Contents LD-G-1n Anleitung 07/2002 Tams Elektronik GmbH NederlandsTable of contents Intended use How to use this manualSafety instructions Mechanical hazardsElectrical hazards Fire risk Thermal dangerOther dangers Information Motorola I and Motorola II format EMC declarationOperation overview Checking the package contents Technical specificationsSafe and correct soldering Required tools and consumablesPerforming a visual check Connecting the LD-G-1Connecting the LD-W-1 Connecting the lighting and other accessoriesConnecting the LEDs Setting the locomotive decoder Using an NEM 652 interface connectorSetting the driving characteristics Setting the locomotive address Operation Emergency stop during active acceleration and brake delaySwitching the shunting gear Improvement of the driving characteristicsManufacturers note FAQCertification Conditional warrantyAdresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1 / LD-W-1 Adresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1LD-G-1 LD-W-1 LD-G-1 / LD-W-1 LD-G-1 / LD-W-1 Tams Elektronik GmbH