Motorola LD-W-1 manual Safety instructions, Mechanical hazards, Electrical hazards

Page 5

English

LD-G-1 / LD-W-1

Safety instructions

Mechanical hazards

Cut wires can have sharp ends and can cause serious injuries. Watch out for sharp edges when you pick up the PCB.

Visibly damaged parts can cause unpredictable danger. Do not use damaged parts: recycle and replace them with new ones.

Electrical hazards

§Do not touch powered, live components.

§Do not touch conducting components which are live due to malfunction.

§Avoid short circuits.

§Do not connect the circuit to a higher voltage than designed.

§Impermissibly high humidity.

§Condensation building up can cause serious injury due to electrical shock.

Take the following precautions to prevent this danger:

§Never perform wiring on a powered module.

§Only use low power for this module as described in this manual and only use certified transformers.

§Connect transformers and soldering stations only in approved mains sockets installed by an authorised electrician.

§Observe cable diameter requirements.

§Assembling the kit should only be done in closed, clean, dry rooms. Beware of humidity.

§If the humidity in the room is too high, please do not start working until after a minimum of 2 hours of acclimatisation.

§Use only original spare parts if you have to repair the kit or the ready-built module.

Page 22

Image 5
Contents LD-G-1n Anleitung 07/2002 Tams Elektronik GmbH NederlandsTable of contents Intended use How to use this manualElectrical hazards Safety instructionsMechanical hazards Other dangers Fire riskThermal danger Information Motorola I and Motorola II format EMC declarationOperation overview Checking the package contents Technical specificationsSafe and correct soldering Required tools and consumablesConnecting the LD-W-1 Connecting the LD-G-1Connecting the lighting and other accessories Performing a visual checkConnecting the LEDs Setting the driving characteristics Setting the locomotive decoderUsing an NEM 652 interface connector Setting the locomotive address Switching the shunting gear Emergency stop during active acceleration and brake delayImprovement of the driving characteristics OperationManufacturers note FAQCertification Conditional warrantyAdresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1 / LD-W-1 Adresse Lötfeld Soldering field Adresse Lötfeld Soldering field LD-G-1LD-G-1 LD-W-1 LD-G-1 / LD-W-1 LD-G-1 / LD-W-1 Tams Elektronik GmbH