Motorola GR300 service manual Programming Over-The-Air, Entering the Program Mode

Page 35

Section 6

Programming

Figure 6-14. Radio Wide Accessory Screen

4.Set the desired custom information.

5.Press F10 to exit.

CAUTION

Repeater mode will not keep custom information.

Therefore, if you customize your radios, you may limit

yourself to always programming in radio mode.

For more information, refer to the Basic RSS Manual.

Programming Over-The-Air

You can program the ZR310 using a portable radio with a DTMF keypad. While programming the unit. it is helpful, but not required, to have a secondary receiver (i.e. scanner, monitor receiver) tuned to the repeater output frequency. This enables you to hear the prompt tones generated by the ZR310. The access code is user-programmable (System Programming, in this section).

All numbers may be entered with or without leading zeros (i.e. the number 1 may be entered as 0001#, 001#, 01# 1#). Some commands send a progress or prompt tone while programming, and all commands send either a "go-ahead" or "error" tone after completion of the command. A "chirp" tone follows a successful command, and a "warble" tone denotes an error. If the programming radio switches slowly from transmit to receive (possibly due to a keypad interdigit transmit hold time), you may program a delay before sending the prompt tones (see the Mic Hold command). Although you do not have to wait for each prompt tone before entering the next command (because all commands are internally buffered), we recommend that you listen for the corresponding tones.

NOTE

At any time while programming the unit, if no DTMF key is pressed for 90 seconds, the ZR310 will exit program mode automatically.

Entering the Program Mode

The transmit radio remains keyed during the program mode to keep other radios from trying to access the system and interface with programming. A command is provided to unkey the transmit radio (diagnostic commands), and if this command is selected, the radio will key only to send prompt tomes.

March, 1993

6880902Z68-O

Section 6-14

Image 35
Contents Radius GR300 Table Of Contents ZR310 Community Repeater Panel Theory of Operation Table Of Contents ZR310 Community Repeater Panel Appendix a Dtmf Commands Overview Standard FeaturesSystem Configuration Section IntroductionPhysical Description User FunctionsSection Introduction Assembly Section InstallationEquipment Required For Installation Installation ProceduresZR310, Rear View Fan Installation Section Installation Section 6880902Z68-O March Part Number Description Qty GR300 Housing Kit HLN8391March 6880902Z68-O Section Section Operation Reserved Users When a User Unkeys RadioRegenerated TPL/DPL/CSQ Carrier RepeatAccessory PTT Encode Reserve ModeBarge In Privacy Mode Stuck Mic Timeout TimerRepeater Set-up/Knockdown Section Theory of Operation Squelch/Repeater Audio TPL EncodingDPL Encoding Beep Tone EncodingSection Maintenance Top Cover Removal TroubleshootingGetting Started Programming Via Radio Service Software RSSSection Programming Programming the Repeater Get/Save, Repeater ModeReading the Transmitter Radio Read Receiver Screen March 6880902Z68-O Section Reading the ReceiverConfiguring the System Command Key Function Morse ID interval, Speed, and Frequency System Programmable FieldsCarrier Only Repeat Open Repeater User Programmable Fields Enable a UserRadio Parameters View All UsersCustomizing Your Accessories Low Battery AlertProgramming Over-The-Air Entering the Program ModeEntering a Command Exiting the Program ModeMic Dtmf Hang Time Program Mode Access CodeSystem Commands Station ID Interval Carrier Repeat CSQ UserSystem ID User Station ID FrequencyStation ID Speed Table A-1. Dtmf System Commands Function Parmeter Appendix a Dtmf CommandsTable A-2. Dtmf Diagnostic Commands Function Parameter