Icom IC-208H instruction manual Programming memory channels, Push Func then CLR AMW

■Programming memory channels

The IC-208H has a total of 512 memory channels (including 10 scan edges and 2 call channels) for storing often used op- erating frequency, repeater settings, etc.

1. Setting a frequency

In VFO mode, set the desired operating frequency with re- peater, tone and tuning steps, etc.

➥Push [V/MHz•SCAN] to select VFO.

➥Rotate [DIAL] to set the desired frequency.

•Set other data, such as repeater tone, duplex information, tuning step), if desired.

QUICK REFERENCE GUIDE

Using the HM-133

qIn VFO mode, set the desired operating frequency, includ- ing offset direction, tone settings, etc.

➥Push [VFO/LOCK] to select VFO.

➥Push [ENT C(T-OFF)] first, then enter the desired oper- ating frequency via the keypad.

•Set other data, such as repeater tone, duplex information, tuning step, if necessary.

wPush [FUNC] then [CLR A(MW)].

•“!” indicator and memory channel number blink.

Quick reference guide

2. Selecting a memory channel

Push [S.MW•MW], then rotate [DIAL] to select the desired memory channel.

• “!” indicator and memory channel number blink.

[S.MW•MW]

3. Writing a memory channel

Push and hold [S.MW•MW] for 1 sec. to program.

•3 beeps sound

•Return to VFO mode automatically after the program.

•Memory channel number automatically increases when continuing to push [S.MW•MW] after programming.

Push , then

ePush [Y]/[Z] to select the desired memory channel.

rPush [FUNC] then push [CLR A(MW)] for 1 sec. to pro- gram.

•3 beeps sound

•Memory channel number automatically increases when continu- ing to push [CLR A(MW)] after programming.

X