Icom IC-208H Offset frequency, Push Band to select the desired frequency SET band

■ Offset frequency [

When communicating through a repeater, the transmit fre- quency is shifted from the receive frequency by an amount determined by the offset frequency.

Independent offset frequencies can be set for each operating frequency.

qPush [BAND] to select the desired frequency band.

wSelect the desired mode/channel you wish to set the offset frequency, such as VFO mode or memory/call channel.

•The offset frequency can be independently programmed into each mode or channel.

ePush [SET•LOCK] to enter set mode.

rPush [SET•LOCK] or [S.MW•MW] until “DUP” and offset frequency appear.

[SET•LOCK] “DUP” and offset frequency appear

tRotate [DIAL] to set the desired offset frequency. yPush [V/MHz•SCAN] to exit set mode.

REPEATER OPERATION 4

zPush [BAND] to select the desired frequency

SET band.

B• Enter the desired frequency via the keypad if neces-

sary. 4

xSelect the desired mode/channel you wish to set the offset frequency, such as VFO mode or memory/call channel.

•The offset frequency can be independently pro- grammed into each mode or channel.

cPush [SET B(D-OFF)] to enter set mode.

vPush [SET B(D-OFF)] or [ENT C(T-OFF)] until “DUP” and offset frequency appear.

Push

bPush [Y] or [Z] to set the desired offset.

•Direct frequency entry from the keypad is not possi- ble.

nPush [CLR A(MW)] to exit set mode.

☞NOTE: The offset frequency can be set in a memory/call channel temporarily. However, the set frequency is cleared once another memory channel or VFO mode is selected. To store the offset frequency permanently, overwrite the channel information.

24