Icom IC-208H Scan start/stop, Preparation, Operation, Push VFO/LOCK to select VFO mode for

7 SCAN OPERATION

■Scan start/stop

DPreparation

Scan resume condition (p. 45); program the scan edges (pgs. 42, 43); program 2 or more memory channels (pgs. 27, 28); set skip settings (p. 44), if desired.

DOperation

qSelect VFO mode for full/programmed scan with [V/MHz•SCAN]; or memory mode for memory scan with [M/CALL•PRIO].

• Select the desired bank for bank scan.

wSet the squelch to the point where noise is just muted. e Push [V/MHz•SCAN] for 1 sec. to start the scan.

•To change the scanning direction, rotate [DIAL].

•The memory channel readout blinks the scan type as follows: r Push [SET•LOCK] to switch full and programmed scan

(P1, P2, P3, P4 and P5), if VFO is selected in step q. t To stop the scan, push [V/MHz•SCAN].

• During full scan • During programmed scan

zPush [VFO/LOCK] to select VFO mode for

SCAN full/programmed scan; push [MR/CALL] to select

2memory mode for memory scan.

• Push [FUNC] then [MONI 1(BANK)] to select a bank

SET for bank scan.

Bx Push [SQLY D(MUTE)] or [SQLZ #(16KEY-L)] to set the squelch to the point where noise is just muted.

cPush [SCAN 2(T-SCAN)] to start the scan.

• Push [Y] or [Z] for 1 sec. also starts the scan.

vPush [SET B(D-OFF)] to switch full and pro- grammed scan (P1, P2, P3, P4 and P5), if VFO is selected in step z.

bTo stop the scan push [SCAN 2(T-SCAN)] or [CLR A(MW)].

• During memory scan • During bank scan

Push [SET•LOCK] to select	Indicates scan edge channels.	Indicates bank initial.
“ALL” (full) or programmed scan	• P1 stands for 1A/1B
(P1, P2, P3, P4 and P5) in se-	• P1 to P5 are available when they
quence.	are programmed, and switches
	with [SET•LOCK].

41