4 BIIS OPERATION
DDirect code entry
qWhile in the standby condition, push [TX Code Enter] to enter the TX code edit mode.
• Editable code digit blinks.
wPush [TX Code Enter] to select the desired digit to be edited.
• Editable digit differs according to the setting.
eSet the desired digit using [
]/[
]/[TX Code CH Up]/[TX
Code CH Down].
rPush [TX Code Enter] to set the digit. The editable digit will move to the right automatically.
tRepeat e and r to input all allowable digits. y Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and “ 
” is displayed during each call. However, an error beep sounds
and “ 
” is displayed when no answer back is received after the calls.
uPush [PTT] to transmit; release to receive.
iPush [P3] (Moni(Audi)) to send the “Clear down” signal.
For your information
When the “UpDate” setting for the call code is enabled, the set code is overwritten into the call code memory.
BIIS OPERATION 4
■Receiving a message
DReceiving a status message
qWhen a status message is received;
• Beeps sound.
• The calling station ID (or text) and the status message is displayed 4 alternately, depending on the setting.
wPush [P3] (Moni(Audi)) to return to the standby condition.
NOTE: Only the calling station ID (or text) is displayed (no message is displayed alternately) when the scroll timer is set to “OFF”. In this case, push [Status Up]/[Status Down] to dis- play the status message manually.
25 | 26 |