Auto emergency transmission, Stun function

4 BIIS OPERATION

■Auto emergency transmission

When [Emergency Single (Silent)] or [Emergency Repeat (Silent)] is pushed, an emergency signal is automatically transmitted for the speciﬁed time period.

The status 22 (Emergency) is sent to the selected ID station, and the position data is transmitted after the emergency signal when a GPS receiver is connected to the transceiver.

The emergency transmission is performed on the emergency chan- nel, however, when no emergency channel is speciﬁed, the signal is transmitted on the previously selected channel.

There is no change in the function display or beep emission during automatic emergency transmission.

■Stun function

When the speciﬁed ID, set as a killer ID, is received, the stun func-

BIIS OPERATION 4

■BIIS indication

The following indications are available for the BIIS operation on an MSK channel.

: Individual/group call is successful.

: Message (status or SDM) transmission is successful.

: No answer back is received.

: Appears during retry of the call (2nd call).

: End the communication.

: Operating channel is in the busy condition.

■Priority A channel selection

When one of the following operations is performed, the transceiver selects the Priority A channel automatically.

Priority A is selected when;

tion is activated.

When the killer ID is received, the transceiver switches to the pass- code required condition. Entering of the passcode via the keypad is necessary to operate the transceiver again in this case.

•Clear down signal is received/transmitted

-Set the “Move to PrioA CH” item as “Clear Down”.

•Turning the power ON

The Priority A channel is selected each time the transceiver power is turned ON.

•Status call

The Priority A channel is selected when transmitting a status call.

-Enable the “Send Status on PrioA CH” item in the MSK con- ﬁguration.