2 PANEL DESCRIPTION
■Programmable function keys
The following functions can be assigned to [P0], [P1], [P2], [P3], [Red], [
] and [
] programmable function keys.
Consult your Icom dealer or system operator for details concerning your transceivers programming.
If the programmable function names are bracketed in the following explanations, the specific switch used to activate the function de- pends on programming.
CH UP AND DOWN KEYS
•Select an operating channel.
•Select a transmit code channel after pushing the [TX Code CH Select] keys.
•Select a DTMF channel after pushing the [DTMF Autodial] key.
•Select a scan group after pushing and holding the [Scan A Start/Stop]/[Scan B Start/Stop] keys.
•Select a BIIS code, status number or SDM after pushing the [Digital] key.
BANK SELECT KEY
Push this key, then push [CH Up] or [CH Down] to select the de- sired bank.
SCAN START/STOP KEYS
➥Push this key to start scanning; and push again to stop.
➥Push and hold this key to indicate the scan group, then select the desired scan group using [CH Up]/[CH Down].
SCAN TAG KEY
Adds or deletes the selected channel to the scan group.
PANEL DESCRIPTION | 2 |
|
PRIORITY CHANNEL KEYS |
|
|
➥ Push to select Priority A or Priority B channel. |
|
|
➥ Push and hold [Prio A (Rewrite)] to rewrite the Prio A channel. |
| 2 |
Select an operating channel directly.
MONITOR KEY
➥Mute and release the CTCSS (DTCS) or
➥Activates one of (or two of) the following functions on each chan- nel independently: (PMR or BIIS PMR operation only)
•Push and hold to
•Push to mute the channel (sets to ‘Inaudible’ only).
•Push to
•Push after the communication is finished to send a ‘reset code’.
NOTE: The
LOCK KEY
Push and hold to electronically lock all programmable keys except the following:
[Call] (incl. Call A and Call B), [Moni(Audi)] and [Emergency] keys.
OUTPUT POWER SELECTION KEY
Select the transmit output power temporarily or permanently, de- pending on the
•Ask your dealer for the output power level for each selection.
7 | 8 |