Mustang Survival MSV971 manual Step a. Replace Inflatable Cell Self-locking Tie

Page 31

Mustang Survival MSV971 Life Preserver and Survival Vest

Description and Maintenance Instructions

9 June 2004, Rev: 1.0

Figure 21. Step a. Replace Inflatable Cell

Self-locking Tie

b.Remove the oral inflator valves and CO2 inflation device from the cell.

c.Reinstall the components removed from the non-serviceable cell onto the replacement cell.

d.Perform the Inflatable Cell Test detailed in Section 5.7.

e.Re-attach the serviceable cell to the protective container with the cell anchor strip. Referring to figures 4 and 22 and starting at the right side, thread the aramid cord loops of the protective container through the grommets of the cell anchor strips. Pass the first cord loop over the top of the second loop and so forth, forming an interlocking arrangement as shown.

Figure 22. Step f. Replace Inflatable Cell

28	This document is for information purposes only. It is not a controlled
	document and may not be considered current when printed.

Image 31

Contents June 9, 2004, REV Table of Contents Vest Sizes Table of FiguresIntroduction 5 Fit TestingAssembled LP/SV FeaturesDesign and Construction GeneralInflatable Cell Life PreserverDocument and may not be considered current when printed Beaded CO2 Inflation Handle Manual CO2 Inflation DeviceProtective Container Oral InflatorGrommet Survival VestSide Adjustment Straps Adjustable Waist BeltRescue Harness System Operation Ballistic Liner Attachment PointsComponent Locations Inflated Cell General Folding and Packing Instructions Donning and Packing InstructionsZipper Closing PositionSliders Step f. Folding and Packing Instructions Harness Loop Step j. Folding and Packing Instructions Step o. Folding and Packing Instructions Fresh Water Immersion Maintenance and CareCleaning Treatment After ImmersionStorage Service LifeMaintenance Reporting Work AreaVisual Inspection Inspection and TestingRequirements PRE-FLIGHT and POST-FLIGHT InspectionVisual Inspection of the Inflatable Cell Maintenance InspectionOral Inflator Valve Test Inflation Manifold Valve TestInflatable Cell Test CO2 Inflation Device Test CO2 Cylinder Inspection and Weight TestSewing RepairsIdentification of Defects Survival Vest or Protective ContainerRepair Materials Damage TreatmentProtective Container Fabric Patching Step b. Patching Steps f. and g. Patching 12 mm 1/2 CO2 Inflation Device Oral Inflator ValveStep a. Replace Inflatable Cell Self-locking Tie CO2 Cylinder Step g. Replace Inflatable Cell Self-locking TieSummary Parts ListMSV971 Survival Vest and Index Numbers Parts List for the MSV971 Survival Vest MM Solas Reflective Tape MSV971 Inflatable Cell and Index Numbers MSV971 Protective Cover and Index Numbers