Cable fed from outside display unit
Shielding foam |
| (D) Rear clamp plate |
|
| (C) Signal clamp |
|
| (Aluminum) |
|
|
|
|
|
|
|
|
|
|
|
|
(A) Rear clamp base 
M5X10 (2 pcs)
(B) Power clamp
(Aluminum)
Bottom clamp front plate (Installation materials)
(Installation materials)
Rear cable entrance
Figure 2-11 Clamp position outside display unit (display unit right side view)
•Place shielding foam between cables inside of display unit, and then attach foam to chassis.
•Fill unused clamp holes with shielding foam.
Cables fed from bottom of display unit (for console mount)
Lead in cables through the cable clamp at the rear of the console and ground their shields in the cable clamp. For signal cable, remove vinyl sheath where cable lies in cable clamp. Fasten cables with cable ties.
CloseCloseshuttershutterdoorandcover it withwithaluminumtapetapeto tokeep foreignkeepobjectsforeignoutobjectsof the out
displayof theunitdisplay. unit.
Seventh hole from the top
| Power Cable | |
| (For display unit) | |
Gyrocompass Log | Signal Cable | |
Performance | NAV | ARPA |
Monitor |
| Slave Display |
Power Cable | ||
(For PM)
Cable Arrangement in the Console (Top view)
SIGNAL CABLE:
Remove the vinyl sheath here. (1300 mm from display unit end
of cable remove sheath by 70 mm.)