Operating the TS400
Operating the TS400
| WARNING: Shock hazard | ||||||||
| The TS400 has On mode and Standby mode only. It does not | ||||||||
| have an Off mode, that is, DC power is permanently connected | ||||||||
| to the unit. | ||||||||
|
|
|
|
|
|
|
|
|
|
On/Standby switch | You can turn the TS400 to On ( |
| ) or to Standby ( |
| ) using the On/Standby | ||||
|
| ||||||||
|
| ||||||||
| |||||||||
| switch (see “Front Panel of the TS400” on page | ||||||||
Optional remote | If you have installed the optional S400 Remote Switch, you can also use | ||||||||
switch | the remote switch to turn the TS400 to On ( |
| ) or to Standby ( |
| ). See | ||||
|
| ||||||||
|
| ||||||||
| “Using the Optional S400 Remote Switch” on page | ||||||||
Resetting the TS400 | The On/Standby switch on the TS400 or the S400 Remote Switch is also | ||||||||
| used to reset the TS400 after a Fault condition. See “Resetting After a | ||||||||
| Fault or Shutdown” on page | ||||||||
Turning the TS400 On
When the On/Standby switch is turned to On (
), the TS400 powers your equipment using energy from the battery.
To turn the TS400 on:
1.Turn the On/Standby switch on the TS400 to the On (
) position. The Inverter ON light illuminates on the TS400.
AND
If you have installed the S400 Remote Switch, turn the S400 Remote Switch to On (
).
2.Operate your equipment.
Turning the TS400 to Standby When Not in Use
When you are not using the TS400 and want to conserve battery power, turn the inverter’s On/Standby switch to the Standby ( 
) position.
To turn the TS400 to standby:
1.Turn your equipment off.
2.Turn the On/Standby switch on the TS400 or the optional S400 Remote Switch to the Standby ( 
) position.
The Inverter ON light turns off.
With the On/Standby switch in Standby ( 
) position, the TS400 draws no current from the battery.