Graco 313888E important safety instructions Setup, Ti4118a

Page 13

Setup

NOTICE

DO NOT USE MATERIALS THAT CURE RAPIDLY! Materials with a fast curing time could plug the pump, hose, gun, or applicator.

1.Fill mixing pail with pre-mixed texture material. Mix per material manufacturer instructions.

ti4118a

Add approximately 10% water to texture mix or per material manufacturer instructions. Mix thoroughly.

2. Connect material hose to pump outlet.

ti14416a

ti13638a

Setup

Prime Pump

1.Start gasoline engine and adjust speed to half throt- tle. Turn prime/drain valve to DRAIN.

ti14632a

2. Place material hose outlet over supply pail.

ti13640a

3. Turn on/off switch ON.

Material and Sprayer Preparation

NOTE: To minimize material pack-out in hose when priming, completely empty hose of all water. In hot con- ditions, it may be necessary to wet the hose with water to lower internal hose temperature, slowing material setup. In this case, water removal is still recommended. If using hose lubricant/wetting solutions, refer to manu- facturer instructions for proper priming techniques.

Cementicious and other curing materials can harden within the drain valve while spraying. At least once per hour stop spraying and open the drain valve to flush out the older material.

3.Pour mixed material into supply pail under sprayer.

4.Place pump suction tube into mixed material.

NOTE: For best results with aggregate, remove strainer.

ti13652a

ti10795b

Base Coat Pump:

Also turn Prime switch ON, or activate applicator switch on material hose.

4.Rotate pump control knob 1/4 turn. Run pump until a steady stream of material flows from drain valve.

ti11930a

313888E

13

Image 13
Contents HTX Contents Fire and Explosion Hazard Recoil Hazard HTX 2030 with Base Coat Pump Product OverviewTop Coat Pump Kit 24B140 When Top Coat Pump is InstalledTop Coat Kit Component Identification SprayerComponent Identification Base Coat Applicator Component Identification HTX2030 Air Spray Trigger Gun Grounding Spray Gun Top Coat Pump Start Engine Ti4118a SetupSpray Spray With Airless TipAir Assisted Spray Base Coat Applicator Spray Without Air Clear ClogDo not USE Materials That Cure Rapidly Air Assisted Spray Air Spray Trigger GunSeat Cleanup Add additional water and repeat steps 12 13 if nec- essary Ti11810a Ti11811a Ti13642a Ti21035a Main Menu Digital Tracking System DTSSecondary Menu Stored Data Mode Display Sprayer Operation Indication Action Digital Display MessagesDaily MaintenanceDimensions Technical Data313888E 313888E Graco Information Graco Standard Warranty