Graco 313888E important safety instructions Cleanup

Page 18

Cleanup

Cleanup

5. Base Coat Pump: Disconnect material hose from pump outlet.

1. Turn on/off switch OFF.

ti10796b

2.Perform Pressure Relief procedure, page 10.

3.Place pump in pail of clean water.

ti13644a

4.Shut OFF air if spraying with air. Remove applicator from material and air hoses.

ti14284a

ti21040a

ti13639a

6.Insert wet cleaning ball into hose (Base Coat Only). Connect material hose to pump outlet.

ti13643a

ti13638a

7. Hold material hose over waste pail.

ti13640a

8.Turn on/off switch ON and prime switch ON, or applicator switch on material hose.

ti10795b

18

313888E

Image 18
Contents HTX Contents Fire and Explosion Hazard Recoil Hazard Product Overview HTX 2030 with Base Coat PumpWhen Top Coat Pump is Installed Top Coat Pump Kit 24B140Component Identification Sprayer Top Coat KitComponent Identification Base Coat Applicator Component Identification HTX2030 Air Spray Trigger Gun Grounding Spray Gun Top Coat Pump Start Engine Setup Ti4118aSpray With Airless Tip SpraySpray Without Air Clear Clog Air Assisted Spray Base Coat ApplicatorAir Assisted Spray Air Spray Trigger Gun Do not USE Materials That Cure RapidlySeat Cleanup Add additional water and repeat steps 12 13 if nec- essary Ti11810a Ti11811a Ti13642a Ti21035a Digital Tracking System DTS Main MenuSecondary Menu Stored Data Mode Digital Display Messages Display Sprayer Operation Indication ActionMaintenance DailyTechnical Data Dimensions313888E 313888E Graco Standard Warranty Graco Information