Graco 313888E Top Coat Pump Kit 24B140, When Top Coat Pump is Installed

Page 6

Product Overview

Top Coat Pump (Kit 24B140)

ti13653a

The pump on the HTX 2030 Sprayer can also be switched out with a Top Coat Kit 24B140 (purchased separately). This pump is used for less viscous materials such as:

•Oil-based coatings

•Enamels

•Latex

•Block fillers

•Elastomerics

•Epoxies

•Drywall mud

•Other high-build materials

For instructions on installing the Top Coat Pump, see manual 313889.

When Top Coat Pump is Installed

•Pump will only run when on/off switch is in ON posi- tion and pump control is rotated clockwise away from OFF position

•Pump control setting adjusts sprayer pressure

a.Rotating knob fully clockwise allows sprayer to reach maximum working pressure of 3300 psi (228 bar, 22.8 MPa)

b.Settings below maximum will lower system pressure

•Pump will run whenever system pressure is below the setting of the pump control

•Sprayer will not respond to Prime switch or Applica- tor switch when Top Coat pump is installed

ti13653a

6

313888E

Page 5 Page 7
Image 6
Page 5 Page 7
Contents HTX Contents Fire and Explosion Hazard Recoil Hazard Product Overview HTX 2030 with Base Coat PumpWhen Top Coat Pump is Installed Top Coat Pump Kit 24B140Component Identification Sprayer Top Coat KitComponent Identification Base Coat Applicator Component Identification HTX2030 Air Spray Trigger Gun Grounding Spray Gun Top Coat Pump Start Engine Setup Ti4118aSpray With Airless Tip SpraySpray Without Air Clear Clog Air Assisted Spray Base Coat ApplicatorAir Assisted Spray Air Spray Trigger Gun Do not USE Materials That Cure RapidlySeat Cleanup Add additional water and repeat steps 12 13 if nec- essary Ti11810a Ti11811a Ti13642a Ti21035a Digital Tracking System DTS Main MenuSecondary Menu Stored Data Mode Digital Display Messages Display Sprayer Operation Indication ActionMaintenance DailyTechnical Data Dimensions313888E 313888E Graco Standard Warranty Graco Information
Top Page Image Contents