Graco 313888E Air Assisted Spray Air Spray Trigger Gun, Do not USE Materials That Cure Rapidly

Page 16

Setup

8.Spray test pattern. Aim applicator at floor. Turn air valve ON. Move applicator to spray surface.

3.Turn air valve OFF. Connect applicator to material hose and air hose. Air supply minimum require- ments vary with material thickness and desired thickness.

ti13646a

9.Adjust air valve and/or select alternative nozzle size (4 - 10mm) for desired finish.

4mm

6mm

8mm

10mm

ti11798a

NOTICE

IF PUMP IS STOPPED LONGER THAN 3 MIN- UTES, TO AVOID PUMP PLUGGING:

Relieve pressure in the pump (See Pressure Relief procedure - page 10).

Recirculate the material by pumping back into original material container.

Air Assisted Spray (Air Spray Trigger Gun)

Due to the high pressure fluid emitted, a strong recoil action may occur when you trigger this gun. If you are unprepared, your hand could be forced back toward your body or you could lose your balance and fall, resulting in serious injury.

1.Prepare material, page 13. Place material hose in supply pail.

2.Turn on/off switch OFF.

ti10796b

ti21263a

NOTICE

DO NOT USE MATERIALS THAT CURE RAPIDLY!

Materials with a fast curing time could plug the pump hose, gun, or applicator.

4. Turn on/off switch ON.

ti10795b

5.Hold applicator over material pail, trigger on, and turn pump ON using applicator switch on hose. NOTE: Remove spray disk then set material flow to prevent material from back-flowing into air passages of gun.

ti21243a

6.Turn pump control clockwise and adjust engine throttle to lowest setting until desired material deliv- ery rate is achieved.

ti8794a

16

313888E

Image 16
Contents HTX Contents Fire and Explosion Hazard Recoil Hazard Product Overview HTX 2030 with Base Coat PumpWhen Top Coat Pump is Installed Top Coat Pump Kit 24B140Component Identification Sprayer Top Coat KitComponent Identification Base Coat Applicator Component Identification HTX2030 Air Spray Trigger Gun Grounding Spray Gun Top Coat Pump Start Engine Setup Ti4118aSpray With Airless Tip SpraySpray Without Air Clear Clog Air Assisted Spray Base Coat ApplicatorAir Assisted Spray Air Spray Trigger Gun Do not USE Materials That Cure RapidlySeat Cleanup Add additional water and repeat steps 12 13 if nec- essary Ti11810a Ti11811a Ti13642a Ti21035a Digital Tracking System DTS Main MenuSecondary Menu Stored Data Mode Digital Display Messages Display Sprayer Operation Indication ActionMaintenance DailyTechnical Data Dimensions313888E 313888E Graco Standard Warranty Graco Information