Graco 313888E important safety instructions Product Overview, HTX 2030 with Base Coat Pump

Page 5

Product Overview

HTX 2030 with Base Coat Pump (257369)

ti13632a

The HTX 2030 Sprayer comes equipped with a Base Coat Pump 24B321. Only water-based materials are to be used with this configuration, such as:

Smooth to heavily aggregated textures with silica sand, perlite, vermiculite and polystyrene

Smooth, medium, coarse and extra coarse textures

Most materials with aggregates up to 2.5 mm (.100 in.) in longest dimension

When Base Coat Pump is Installed

Pump will only run when on/off switch is in ON position AND:

Pump control is rotated clockwise away from OFF position, and either of the following switches are also switched ON:

Prime Switch on pressure control box AND/OR Applicator Switch near end of material hose

The pressure control will limit the sprayer to 1,000 psi (69 bar), stopping the pump whenever pressure limit is reached.

Product Overview

Flow rate is dependent on engine speed and the setting of the pump control knob.

1.Flow 3 (fully clockwise) - allows the pump to run continuously with minimal pulsation:

ti13756a

2.Flow 2 (near middle of the rotation) reduces flow slightly by briefly interrupting pump:

ti13757a

3.Flow 1 (near counterclockwise end of pump control) reduces flow more by interrupting pump longer:

ti13758a

4.OFF (fully counterclockwise) - stops pump com- pletely:

ti13755a

5.Adjust engine speed to control flow rate of sprayer. Start with the slowest speed possible for maximum spray control. Different spray tip nozzle sizes can also be tried.

ti5251a

313888E

5

Image 5
Contents HTX Contents Fire and Explosion Hazard Recoil Hazard HTX 2030 with Base Coat Pump Product OverviewTop Coat Pump Kit 24B140 When Top Coat Pump is InstalledTop Coat Kit Component Identification SprayerComponent Identification Base Coat Applicator Component Identification HTX2030 Air Spray Trigger Gun Grounding Spray Gun Top Coat Pump Start Engine Ti4118a SetupSpray Spray With Airless TipAir Assisted Spray Base Coat Applicator Spray Without Air Clear ClogDo not USE Materials That Cure Rapidly Air Assisted Spray Air Spray Trigger GunSeat Cleanup Add additional water and repeat steps 12 13 if nec- essary Ti11810a Ti11811a Ti13642a Ti21035a Main Menu Digital Tracking System DTSSecondary Menu Stored Data Mode Display Sprayer Operation Indication Action Digital Display MessagesDaily MaintenanceDimensions Technical Data313888E 313888E Graco Information Graco Standard Warranty