DMX Linking, DMX Modes Master/Slave Connectivity

Setup

DMX Linking

DMX Modes

Master/Slave Connectivity

You may link the Q-Wash 560Z-LED to a DMX controller using a standard DMX serial connection. If using other DMX compatible products with the Q-Wash 560Z-LED, you can control each individually with a single DMX controller.

The Q-Wash 560Z-LED uses the standard DMX data connection for its Basic, Advanced, and G1 DMX modes.

Refer to the Introduction chapter for a brief description of these modes.

Refer to the Operation chapter to learn how to configure the Q-Wash 560Z-LED to work in these modes.

The DMX Values section will provide you with detailed information regarding the DMX modes.

The Master/Slave mode enables a Q-Wash 560Z-LED (the “master product”) to control one or more Q-Wash 560Z-LEDs (the “slave products”) without a DMX controller. One Q-Wash 560Z-LED becomes the master product when running an Auto or Custom program.

You must configure each slave product’s control panel to operate in SLAVE mode. During Master/Slave operation, the slave products will operate in unison with the master product.

If you are not familiar with or need more information about DMX standards, master/slave connectivity, or the DMX cables needed to link this product to a DMX controller, download the document DMX Primer from the CHAUVET® website: www.chauvetpro.com.

DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX controller signals may interfere with the signals from the master product.

The Operation chapter of this manual provides detailed instructions on how to configure the Master and Slave products.

-8-	Q-Wash 560Z-LED User Manual Rev. 12