ASSEMBLY INSTRUCTIONS
LEFT SIDE – Install (4) 5/16" x 1" button head bolts with (4) black flat washers and (4) NYLON SHOULDER WASHERS into the left side of the upright (see Figure 3). Install bolts and washers by hand. Make sure shoulder washers are seated properly in the holes of the upright before tightening.
RIGHT SIDE – Install (4) 5/16" x 1" button head bolts with (4) black flat washers and (4) STAR WASHERS into the right side of the upright (see Figure 4). Install bolts and washers by hand.
Now tighten all bolts with the provided hex key. Tighten out- side bolts first, then the bolts on the front of the unit.
FIGURE 4
Black Flatwasher
1” Button head
Star washer
STEP 5
Cut rubber band on the right upright leg to access the cable wires (see Figure 5). Insert cable wire connectors into their respective sockets on the power supply board (see Figure 6).
STEP 6
Fold up slack in the exposed cable wires and insert loose wires into the provided wire clips (see Figure 7). CAUTION: make sure when routing wires that they cannot come into contact with moving parts.
STEP 7
Reinstall motor cover using the (7) Phillips head screws.
STEP 8 | Right Upright |
Attach the top of the right handrail (marked with an “R”) to the right side of the upright using the 5/16 x 5” long hex head bolt and flat washer. Hand tighten only. (see figure 8).
FIGURE 7 | FIGURE 6 | FIGURE 5 |
|
6