Cabinet Maintenance, Specifications, On page

English

6. Tighten from below using the	SPECIFICATIONS
supplied screws (three locations).	Cabinet		Bass-reﬂex type
	Cabinet		Bass-reﬂex type
• Tighten the three screws in order ➀, ➁, ➂ as shown in	Used speaker (two-way system):
the diagram (see page 7).	Woofer (for low tones)	4.8 cm ⋅ 13 cm cone type
The screw hole at the rear surface of the speaker bracket	Tweeter (for high tones)		2.5 cm semidome type
is used when the ﬂat screen TV is installed with the table	Impedance		6 Ω
top stand. It is not used when installed on the wall.	Frequency Range		60 Hz to 30 000 Hz
NOTE:	Sensitivity (1 m, 1 W)		80 dB
NOTE:	Permissible input :
If after attaching the speaker its position needs to be	Max. input		18 W
adjusted horizontally, first loosen the speaker mounting	Rated input		6 W
screws, reposition and then tighten the screws again at the	Crossover frequency		3 kHz
appropriate position.	External Dimensions
	..............................1 233 (W) mm ⋅ 78 (H) mm ⋅ 93 (D) mm
7. Bundling the cables (See procedure 7	Weight :
7. Bundling the cables (See procedure 7	Speaker only		2.8 kg
on page 6).	With cables, brackets and screws		...............................3.2 kg
	Accessory parts
CABINET MAINTENANCE	.................................................................		Speaker Cables ⋅ 2
CABINET MAINTENANCE	....................................................................		Speaker Brackets
• Use a polishing cloth or dry cloth to wipe off dust and dirt.			Side ⋅ 2
			Center ⋅ 1
• When the cabinet is very dirty, wipe with a soft cloth			Center ⋅ 1
• When the cabinet is very dirty, wipe with a soft cloth	...................... Speaker Mounting Screws (M5 ⋅ 10 mm) ⋅ 9
moistened with water-diluted cleanser; then wipe again	.....................................................	Operating Instructions ⋅ 1
with a dry cloth. Do not use furniture wax or cleaners.

	They may damage the surface of the cabinet.	NOTE:
	• Never use thinner, benzine, insecticide sprays and other	NOTE:
	• Never use thinner, benzine, insecticide sprays and other	Specifications and design subject to possible modification
	chemicals on or near the cabinets, since these will	Specifications and design subject to possible modification
	chemicals on or near the cabinets, since these will	without notice, due to improvements.
	corrode the surfaces.	without notice, due to improvements.
	corrode the surfaces.
	• When a chemical cloth is used, read the cautions for the
	chemical cloth carefully.

��

Published by Pioneer Corporation.

6. Tighten from below using the

SPECIFICATIONS

supplied screws (three locations).

appropriate position.

7. Bundling the cables (See procedure 7

on page 6).

CABINET MAINTENANCE

without notice, due to improvements.