Lowrance electronic manual X52 and X59DF

Page 1

Pub. 988-0151-211

www.lowrance.com

X52 and X59DF

Fish-Finding & Depth-Sounding Sonars

Installation and Operation Instructions

Image 1

Contents X52 and X59DF Lowrance Electronics Inc 12000 E. Skelly Dr Tulsa, OK USA Table of Contents Fish I.D. Fish Symbols & Depths Introduction Capabilities and Specifications X52 and X59DFFeet 244 meters at 200 kHz 1500 feet Preparations Transducer InstallationDual-frequency transom installations Single-frequency transom installationsSingle-frequency trolling motor installations Shoot-through hull installationsGood location Poor location Location Poor angle Pad Deadrise less than StrakesTransom Transducer centerline Hull bottom Dot Ratchet Ratchets Metal Nut washer Rubber Washers Metal washer Bolt Lock washer Bolt Nut Flat washerTransom Bottom Hull Flat-bottom hull Deep-vee hull Internal tooth washer Trolling Motor Bracket InstallationBolt Nut Transducer aimed Partial fish archesShoot-Thru-Hull Preparation Transducer location High speed Trolling speed True bottom Second bottom Manual range settingShoot-Thru-Hull Installation Epoxy transducer to hull Speed/Temperature Sensors Good location Power ConnectionsTransom Bottom of hull Powering a Nmea 2000 Buss Nmea 2000 Power cable Page Power connections for the units in this series Nmea 0183 Cable Connections Nmea 2000 Cable ConnectionsTo Nmea To sonar Network port Units Network Socket Mounting the Unit Bracket, In-Dash or Portable Front 136 61.3 132 23.8 147.4 Millimeter Inch Hole Diameter 121Inches 112 Cut on line Other Accessories Page Basic Sonar Operation Menus MemoryMain Menu Commands Sonar Menu Commands Pages Page Page Basic Sonar Quick Reference Bait School Thermocline With fish Fish Arches Sonar OperationsTo adjust sensitivity Important Tip To Restore Factory SettingsOther Free Training Aids ASP Advanced Signal Processing Advanced Sonar Options & Other FeaturesTo adjust and turn on the shallow alarm AlarmsTo turn the fish alarm on To adjust and turn on the deep alarmBacklight Level Chart SpeedCalibrate Speed Grayline Thin or no Grayline Wider Grayline ContrastCursor line Depth box Depth CursorDepth Range Automatic To switch to Manual Depth RangeDepth Range Manual To turn Auto Depth Range on againArea zoomed Depth Range Upper and Lower LimitsFasTrack Fish I.D. Fish Symbols & DepthsFishTrack Press ↓ to Fish ID SymbolsentexitexitHyperScroll Symbols with FishTrack depthsNoise Rejection Overlay DataTo turn off displayed data To change displayed data font size Ping Speed & HyperScrollFrom the Sonar Page, press MENU↓ to Ping Speedent Pop-up Help Reset OptionsScreen Contrast and Backlight Level Reset Water DistanceSensitivity & Auto Sensitivity Automatic Sensitivity Set Keel Offset Software Version Information Set LanguagePress MENUMENU↓ to SET Keel Offsetent Sonar Page & Sonar Chart Display Options Sonar Chart ModePress MENUMENU↓ to Software Infoent Split Zoom Sonar Chart Digital Data/Chart Sonar Simulator Stop ChartSurface Clarity Press ↓ or ↑ to select clarity levelEXITEXITEXIT Units of MeasureUpper and Lower Limits VolumeZoom & Zoom Bar Zoom Pan Troubleshooting No fish arches when the Fish I.D. feature is off Noise Page Index Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site