Lowrance electronic X59DF, X52 manual Accessory Ordering Information for all countries

Page 83

Accessory Ordering Information for all countries

To order Lowrance accessories, please contact:

1)Your local marine dealer. Most quality dealers that handle marine electronic equipment should be able to assist you with these items.

To locate a Lowrance dealer near you, visit our web site and look for the Dealer Locator (www.lowrance.com/support/dealerlocator). Or, you can consult your telephone directory for listings.

2)U.S. customers: LEI Extras Inc., PO Box 129, Catoosa, OK 74015-0129 Call 1-800-324-0045 or visit our web site www.lei-extras.com.

3)Canadian customers can write:

Lowrance/Eagle Canada, 919 Matheson Blvd. E. Mississauga, Ontario L4W2R7 or fax 905-629-3118.

Shipping Information

If it becomes necessary to send a product for repair or replacement, you must first receive a return authorization number from Customer Service. Products shipped without a return authorization will not be accepted. When shipping, we recommend you do the following:

1.Please do not ship the knobs or mounting bracket with your unit.

2.If you are sending a check for repair, please place your check in an envelope and tape it to the unit.

3.For proper testing, include a brief note with the product describing the problem. Be sure to include your name, return shipping address and a daytime telephone number. An e-mail address is optional but useful.

4.Pack the unit in a suitable size box with packing material to prevent any damage during shipping.

5.Write the Return Authorization (RA) number on the outside of the box underneath your return address.

6.For your security, you may want to insure the package through your shipping courier. Lowrance does not assume responsibility for goods lost or damaged in transit.

Image 83
Contents X52 and X59DF Lowrance Electronics Inc 12000 E. Skelly Dr Tulsa, OK USA Table of Contents Fish I.D. Fish Symbols & Depths Introduction Capabilities and Specifications X52 and X59DFFeet 244 meters at 200 kHz 1500 feet Preparations Transducer InstallationShoot-through hull installations Single-frequency transom installationsDual-frequency transom installations Single-frequency trolling motor installationsGood location Poor location Location Poor angle Pad Deadrise less than StrakesTransom Transducer centerline Hull bottom Dot Ratchet Ratchets Metal Nut washer Rubber Washers Metal washer Bolt Lock washer Bolt Nut Flat washerTransom Bottom Hull Flat-bottom hull Deep-vee hull Bolt Nut Trolling Motor Bracket InstallationInternal tooth washer Transducer aimed Partial fish archesShoot-Thru-Hull Preparation Transducer location High speed Trolling speed True bottom Second bottom Manual range settingShoot-Thru-Hull Installation Epoxy transducer to hull Speed/Temperature Sensors Transom Bottom of hull Power ConnectionsGood location Powering a Nmea 2000 Buss Nmea 2000 Power cable Page Power connections for the units in this series To Nmea To sonar Network port Units Network Socket Nmea 2000 Cable ConnectionsNmea 0183 Cable Connections Mounting the Unit Bracket, In-Dash or Portable Front 136 61.3 132 23.8 147.4 Millimeter Inch Inches 112 Cut on line 121Hole Diameter Other Accessories Page Basic Sonar Operation Menus MemoryMain Menu Commands Sonar Menu Commands Pages Page Page Basic Sonar Quick Reference Bait School Thermocline With fish Fish Arches Sonar OperationsTo adjust sensitivity Important Tip To Restore Factory SettingsOther Free Training Aids ASP Advanced Signal Processing Advanced Sonar Options & Other FeaturesTo adjust and turn on the shallow alarm AlarmsTo turn the fish alarm on To adjust and turn on the deep alarmCalibrate Speed Chart SpeedBacklight Level Grayline Thin or no Grayline Wider Grayline ContrastCursor line Depth box Depth CursorTo turn Auto Depth Range on again To switch to Manual Depth RangeDepth Range Automatic Depth Range ManualArea zoomed Depth Range Upper and Lower LimitsFasTrack Fish I.D. Fish Symbols & DepthsFishTrack Press ↓ to Fish ID SymbolsentexitexitOverlay Data Symbols with FishTrack depthsHyperScroll Noise RejectionTo turn off displayed data To change displayed data font size Ping Speed & HyperScrollFrom the Sonar Page, press MENU↓ to Ping Speedent Pop-up Help Reset OptionsSensitivity & Auto Sensitivity Reset Water DistanceScreen Contrast and Backlight Level Automatic Sensitivity Set Keel Offset Press MENUMENU↓ to SET Keel Offsetent Set LanguageSoftware Version Information Press MENUMENU↓ to Software Infoent Sonar Chart ModeSonar Page & Sonar Chart Display Options Split Zoom Sonar Chart Digital Data/Chart Sonar Simulator Stop ChartSurface Clarity Press ↓ or ↑ to select clarity levelEXITEXITEXIT Units of MeasureZoom & Zoom Bar VolumeUpper and Lower Limits Zoom Pan Troubleshooting No fish arches when the Fish I.D. feature is off Noise Page Index Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site