Lowrance electronic X59DF, X52 manual Power connections for the units in this series

Page 27

	Blue connector
	Blue connector
	To power a	To unit
	NMEA 2000	To unit
	NMEA 2000
	buss, also
	connect
	NMEA 2000
	Power cable
	to the boat's
	battery.

White external speaker wire (not used by this unit)

Black wire

Optional power off
switch for salt-	12 volt
water installations	battery

Red wire with

3 amp fuse

NMEA 0183 NMEA 2000 Power Cable

Data Cable

Power connections for the units in this series.

NOTES:

If you're powering a NMEA 2000 buss, you will attach both the NMEA 2000 Power cable and the unit's Power Supply cable to the boat's battery. To attach the NMEA 2000 Power cable, connect the red wire to battery's + and black and shield wires to battery's –.

If you are not powering a NMEA 2000 buss, we recommend capping all unused, exposed wire ends with wire nuts or electrical tape and tucking the excess cable out of the way. This will prevent an electrical short.

WARNING:

This product must be independently fused with the enclosed 3-amp fuse (or equivalent), even if you connect to a fused accessory or power buss.

If a malfunction happens inside the unit, extensive damage can occur if the enclosed fuse is not used. As with all electrical devices, this unit could be damaged to a point that it is unrepairable and could even cause harm to the user when not properly fused.

CAUTION:

Do not use this product without a 3-amp fuse wired into the power cable! Failure to use a 3-amp fuse will void your warranty.

23

Image 27

Contents X52 and X59DF Lowrance Electronics Inc 12000 E. Skelly Dr Tulsa, OK USA Table of Contents Fish I.D. Fish Symbols & Depths Introduction Capabilities and Specifications X52 and X59DFFeet 244 meters at 200 kHz 1500 feet Preparations Transducer InstallationShoot-through hull installations Single-frequency transom installationsDual-frequency transom installations Single-frequency trolling motor installationsGood location Poor location Location Poor angle Pad Deadrise less than StrakesTransom Transducer centerline Hull bottom Dot Ratchet Ratchets Metal Nut washer Rubber Washers Metal washer Bolt Lock washer Bolt Nut Flat washerTransom Bottom Hull Flat-bottom hull Deep-vee hull Trolling Motor Bracket Installation Internal tooth washerBolt Nut Transducer aimed Partial fish archesShoot-Thru-Hull Preparation Transducer location High speed Trolling speed True bottom Second bottom Manual range settingShoot-Thru-Hull Installation Epoxy transducer to hull Speed/Temperature Sensors Power Connections Good locationTransom Bottom of hull Powering a Nmea 2000 Buss Nmea 2000 Power cable Page Power connections for the units in this series Nmea 2000 Cable Connections Nmea 0183 Cable ConnectionsTo Nmea To sonar Network port Units Network Socket Mounting the Unit Bracket, In-Dash or Portable Front 136 61.3 132 23.8 147.4 Millimeter Inch 121 Hole DiameterInches 112 Cut on line Other Accessories Page Basic Sonar Operation Menus MemoryMain Menu Commands Sonar Menu Commands Pages Page Page Basic Sonar Quick Reference Bait School Thermocline With fish Fish Arches Sonar OperationsTo adjust sensitivity Important Tip To Restore Factory SettingsOther Free Training Aids ASP Advanced Signal Processing Advanced Sonar Options & Other FeaturesTo adjust and turn on the shallow alarm AlarmsTo turn the fish alarm on To adjust and turn on the deep alarmChart Speed Backlight LevelCalibrate Speed Grayline Thin or no Grayline Wider Grayline ContrastCursor line Depth box Depth CursorTo turn Auto Depth Range on again To switch to Manual Depth RangeDepth Range Automatic Depth Range ManualArea zoomed Depth Range Upper and Lower LimitsFasTrack Fish I.D. Fish Symbols & DepthsFishTrack Press ↓ to Fish ID SymbolsentexitexitOverlay Data Symbols with FishTrack depthsHyperScroll Noise RejectionTo turn off displayed data To change displayed data font size Ping Speed & HyperScrollFrom the Sonar Page, press MENU↓ to Ping Speedent Pop-up Help Reset OptionsReset Water Distance Screen Contrast and Backlight LevelSensitivity & Auto Sensitivity Automatic Sensitivity Set Keel Offset Set Language Software Version InformationPress MENUMENU↓ to SET Keel Offsetent Sonar Chart Mode Sonar Page & Sonar Chart Display OptionsPress MENUMENU↓ to Software Infoent Split Zoom Sonar Chart Digital Data/Chart Sonar Simulator Stop ChartSurface Clarity Press ↓ or ↑ to select clarity levelEXITEXITEXIT Units of MeasureVolume Upper and Lower LimitsZoom & Zoom Bar Zoom Pan Troubleshooting No fish arches when the Fish I.D. feature is off Noise Page Index Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site