Lowrance electronic X59DF, X52 manual

Page 41

Sonar chart display options (from left) digital data and flasher.

You can customize how the Sonar Page pictures and other data are displayed in many ways. We'll discuss all of those features and options in the Advanced Section, but to show you how easy the sonar unit is to operate, the following page contains a simplified, 10-step quick reference that will cover most fish finding situations. The quick reference describes how your unit will operate with all the sonar features in their automatic modes, which are set at the factory.

37

Image 41

Contents X52 and X59DF Lowrance Electronics Inc 12000 E. Skelly Dr Tulsa, OK USA Table of Contents Fish I.D. Fish Symbols & Depths Introduction Capabilities and Specifications X52 and X59DFFeet 244 meters at 200 kHz 1500 feet Preparations Transducer InstallationDual-frequency transom installations Single-frequency transom installationsSingle-frequency trolling motor installations Shoot-through hull installationsGood location Poor location Location Poor angle Pad Deadrise less than StrakesTransom Transducer centerline Hull bottom Dot Ratchet Ratchets Metal Nut washer Rubber Washers Metal washer Bolt Lock washer Bolt Nut Flat washerTransom Bottom Hull Flat-bottom hull Deep-vee hull Bolt Nut Trolling Motor Bracket InstallationInternal tooth washer Transducer aimed Partial fish archesShoot-Thru-Hull Preparation Transducer location High speed Trolling speed True bottom Second bottom Manual range settingShoot-Thru-Hull Installation Epoxy transducer to hull Speed/Temperature Sensors Transom Bottom of hull Power ConnectionsGood location Powering a Nmea 2000 Buss Nmea 2000 Power cable Page Power connections for the units in this series To Nmea To sonar Network port Units Network Socket Nmea 2000 Cable ConnectionsNmea 0183 Cable Connections Mounting the Unit Bracket, In-Dash or Portable Front 136 61.3 132 23.8 147.4 Millimeter Inch Inches 112 Cut on line 121Hole Diameter Other Accessories Page Basic Sonar Operation Menus MemoryMain Menu Commands Sonar Menu Commands Pages Page Page Basic Sonar Quick Reference Bait School Thermocline With fish Fish Arches Sonar OperationsTo adjust sensitivity Important Tip To Restore Factory SettingsOther Free Training Aids ASP Advanced Signal Processing Advanced Sonar Options & Other FeaturesTo adjust and turn on the shallow alarm AlarmsTo turn the fish alarm on To adjust and turn on the deep alarmCalibrate Speed Chart SpeedBacklight Level Grayline Thin or no Grayline Wider Grayline ContrastCursor line Depth box Depth CursorDepth Range Automatic To switch to Manual Depth RangeDepth Range Manual To turn Auto Depth Range on againArea zoomed Depth Range Upper and Lower LimitsFasTrack Fish I.D. Fish Symbols & DepthsFishTrack Press ↓ to Fish ID SymbolsentexitexitHyperScroll Symbols with FishTrack depthsNoise Rejection Overlay DataTo turn off displayed data To change displayed data font size Ping Speed & HyperScrollFrom the Sonar Page, press MENU↓ to Ping Speedent Pop-up Help Reset OptionsSensitivity & Auto Sensitivity Reset Water DistanceScreen Contrast and Backlight Level Automatic Sensitivity Set Keel Offset Press MENUMENU↓ to SET Keel Offsetent Set LanguageSoftware Version Information Press MENUMENU↓ to Software Infoent Sonar Chart ModeSonar Page & Sonar Chart Display Options Split Zoom Sonar Chart Digital Data/Chart Sonar Simulator Stop ChartSurface Clarity Press ↓ or ↑ to select clarity levelEXITEXITEXIT Units of MeasureZoom & Zoom Bar VolumeUpper and Lower Limits Zoom Pan Troubleshooting No fish arches when the Fish I.D. feature is off Noise Page Index Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site