Graco 309909H important safety instructions Removal, Software Upgrades

Page 16

Repair

User Interface

Removal

1.Close main air shutoff valve on air supply line and on unit.

2.Remove side panels (21).

3.Remove fasteners (45). Gently pull user interface (11) away from pneumatic control (10).

	21	10
	21	315
		315

45

11

TI4901a

FIG. 1

4.To completely remove user interface (11), discon- nect ground wire (315), and wires (416 and 406) from main control board (301). See Electrical Schematic, page 22.

Software Upgrades

CAUTION

To avoid damaging circuit board, wear a grounding strap.

1.Remove User Interface cover. See above.

2.Use a chip remover (D) to remove software chip (C). FIG. 2.

C

D

FIG. 2

3.Install new chip (beveled corner down).

4.Reassemble.

5.Recalibrate main circuit board. See ProMix Easy Operation Manual.

16

309909H

Image 16

Contents Repair Parts Important Safety InstructionsContents Manual ConventionsProMix Easy Models Series Description Psi MPa, bar ApprovalsRelated Manuals Component Manuals in English DescriptionFire and Explosion Hazard Equipment Misuse Hazard Pressure Relief Procedure Fluid Manifold to GunPump to Fluid Manifold Maintenance Problem SolutionTroubleshooting Problem Cause SolutionCircuit. See Electrical Schematic, Relieve pressure. Install larger tip. Follow Operating Errors Startup ErrorsCode Code Alarm Active Problem Cause Testing ErrorRepair Replacing Air Filter ElementSoftware Upgrades RemovalReplacing Main Circuit Board Replacing Display Circuit Board Pneumatic Control Alternator RepairReplacing Solenoids Replacing AlarmReplacing Alternator Regulator Dispense Valve/Mix Manifold Assembly Follow Pressure Relief Procedure,Schematic Main Control Board Schematic Pump Solenoid Expansion Board SchematicMain Control Board LEDs PinParts Part No Series A, Pump-based, Cart-mounted Air Spray UnitCable Connections 78 RefNo. Part No. Description Pump and Meter-based, Wall-mounted Air Spray Units Pump Solenoid Cable Connections See page 27 for model numbers and descriptions Description QtyPump-based, Wall-mounted Air Spray Units 494025 24 Ref See page 30 for model numbers and descriptions Meter-based, Wall-mounted High Pressure Units 65 Ref 4025 24 Ref See page 33 for model numbers and descriptions Pump-based, Wall-mounted High Pressure Units Muffler See page 36 for model numbers and descriptions Ft 5.2 ft Pump and Meter-based, Wall-mounted High Pressure Units TI4908a See page 40 for model numbers and descriptions MufflerCheck Valve Tube Connections, Low Pressure Pumps SideTube Connections, High Pressure Pumps P2P1Tube Connections, Meters C1G1 P2 M1Pneumatic Schematic Intrinsically Safe Pneumatic Control Part No. Description QtyAlternator Module 304 Detail Solenoid Module 306 DetailNon-intrinsically Safe Pneumatic Control 307 User Interface DisplayPump Air Control Meter Air Control No. Part No. Description QtyTechnical Data Technical Data Graco Standard Warranty Graco Information