Graco 309909H important safety instructions Equipment Misuse Hazard

Page 6

Warnings

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

•Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

•Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings.

•Check equipment daily. Repair or replace worn or damaged parts immediately.

•Do not alter or modify equipment.

•For professional use only.

•Use equipment only for its intended purpose. Call your Graco distributor for information.

•Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

•Do not kind or overbend hoses or use hoses to pull equipment.

•Comply with all applicable safety regulations.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

•Read MSDS’s to know the specific hazards of the fluids you are using.

•Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, inhalation of toxic fumes, burns, and hearing loss. This equipment includes but is not limited to:

• Protective eyewear

•Clothing and respirator as recommended by the fluid and solvent manufacturer

•Gloves

•Hearing protection

6

309909H

Image 6

Contents Repair Parts Important Safety InstructionsContents Manual ConventionsProMix Easy Models Series Description Psi MPa, bar ApprovalsRelated Manuals Component Manuals in English DescriptionFire and Explosion Hazard Equipment Misuse Hazard Pressure Relief Procedure Fluid Manifold to GunPump to Fluid Manifold Maintenance Problem SolutionTroubleshooting Problem Cause SolutionCircuit. See Electrical Schematic, Relieve pressure. Install larger tip. Follow Startup Errors Operating ErrorsCode Code Alarm Active Problem Cause Testing ErrorRepair Replacing Air Filter ElementSoftware Upgrades RemovalReplacing Main Circuit Board Replacing Display Circuit Board Pneumatic Control Alternator RepairReplacing Alarm Replacing SolenoidsReplacing Alternator Regulator Dispense Valve/Mix Manifold Assembly Follow Pressure Relief Procedure,Schematic Main Control Board LEDs Main Control Board SchematicPump Solenoid Expansion Board Schematic PinParts Part No Series A, Pump-based, Cart-mounted Air Spray UnitCable Connections 78 RefNo. Part No. Description Pump and Meter-based, Wall-mounted Air Spray Units Pump Solenoid Cable Connections See page 27 for model numbers and descriptions Description QtyPump-based, Wall-mounted Air Spray Units 494025 24 Ref See page 30 for model numbers and descriptions Meter-based, Wall-mounted High Pressure Units 65 Ref 4025 24 Ref See page 33 for model numbers and descriptions Pump-based, Wall-mounted High Pressure Units Muffler See page 36 for model numbers and descriptions Ft 5.2 ft Pump and Meter-based, Wall-mounted High Pressure Units TI4908a See page 40 for model numbers and descriptions MufflerCheck Valve Tube Connections, Low Pressure Pumps SideTube Connections, High Pressure Pumps P2P1Tube Connections, Meters C1G1 P2 M1Pneumatic Schematic Intrinsically Safe Pneumatic Control Part No. Description QtyAlternator Module 304 Detail Solenoid Module 306 DetailNon-intrinsically Safe Pneumatic Control 307 User Interface DisplayPump Air Control Meter Air Control No. Part No. Description QtyTechnical Data Technical Data Graco Standard Warranty Graco Information