JVC KM-H2500U, KM-H3000U, KM-H3000E, KM-H2500E Tallies, Selecting a Source for the Aux Buses

1

2

1.Press AUX SEL to display the Aux menu.

2.Select an Aux bus by pressing the corresponding knob.

To access Aux buses on the KM-H3000:

1.Select the Aux bus you wish to choose a source on.

2.Press and hold SHIFT on the Key/Aux bus.

3.Press any of AUX PGM, AUX PV, AUX CLN, or the fourth source button (to access Chroma Key Alpha) on the Preset bus.

Tallies

The switcher has tally relays assigned to inputs as follows (pin 1 is the top right pin when looking at the Tally Port):

1

1.Select the desired Aux bus by pressing AUX 1 - 3.

Selecting a Source for the Aux Buses

Once an Aux bus has been selected, you can change the source.

To select a source for an Aux bus:

1.Select the Aux bus you wish to choose a source on.

2.Press the desired source button on the Key/Aux bus.

Selecting a Special Source for the Aux Buses

You can select the following special sources by selecting them on the Preset bus:

•Program (AUX PGM)

•Preview (AUX PV)

•Clean Feed (AUX CLN)

•Chroma Key Alpha (fourth source button)

5 4 3 2 1

9 8 7 6

Figure 11 Tally Port

11

23

35

47

5Common Ground

62

74

86

98

When the corresponding input is on-air, the associated tally pin is closed, creating a contact closure.

Note:

•Tally wiring can be difficult. Consult with your facility engineer before undertaking any tally wiring.

For More Information on...

•port locations, refer to the section “Control Panel Rear Connections Overview” on page 2