Tascam GVI owner manual

Page 17

Note: This parameter is only available if the Cutoff Controller is set to “None”.

Minimum (Min) Cutoff: This value places a limit on the lowest filter cutoff frequency when using a MIDI Cutoff Controller. The low range of the MIDI controller will start with this value.

Resonance (Res): Resonance, also referred to as Q, creates a peak in amplitude at the specific Cutoff frequency and is used to generate classic analog synth textures. The maximum resonance is set close to the point of self-oscillation and will resonate according to the frequency content of the waveform that is being filtered.

Dynamic (Dyn): Enabling Dynamic increases the overall resonance by dynamically scaling the Q in addition to the cutoff frequency of the filter over changes of envelope and/or external control.

17

Image 17

Contents QuickEdit and GigaPulse Addendum Quickedit View Quickedit View Midi Select Edit Modes and SelectionsKeyboard Select DROP-DOWN Menu Edit ModeDimension Select DROP-DOWN Menu GVI General TAB Quickedit Articulation TabsVelocity Response Section Volume Modulation SectionLinear Curve Non-Linear Curve Special Curve GVI AMPLITUDE/PITCH TAB Instrument Global SectionAmplitude Envelope Section AMP Envelope Modulation Section Pitch Envelope SectionAmplitude LFO Section Pitch LFO Section Filter Section GVI Filter TABPage Filter Envelope Section KEY Response Section Midi Control SectionFilter Envelope Modulation Section Filter LFO Section Loop Section GVI Loop TABSample Start Section Waveform View Zoom Tools Quickedit Waveform ViewEnvelope and LFO Selection Waveform Display WindowGigapulse View Opening the Gigapulse UI Gigapulse in the Midi MixerAcoustic Space Section Input SectionMic Group Selection Menu MIC Group SectionPage Page MIC Replacement Section Page GVI Placement Section MIC to FX BUS Routing Section