Tascam owner manual GVI Loop TAB, Sample Start Section, Loop Section

Page 21

GVI LOOP TAB

SAMPLE START SECTION

Sample Start: This option alters the sample attack to start after the beginning of the wave sample. The value is measured in samples and has maximum limit of 2000 samples. This is useful to soften the attack of a sample or to eliminate/create pops at the beginning of a sample.

LOOP SECTION

This section is only available for samples that already have a loop enabled.

Loop Start: Adjusts a defined loop’s start point

Loop End: Adjusts a defined loop’s end point

Note: The loop points are also visible and adjustable in the Waveform View window. The Green marker is the loop start and the Red marker is the loop end.

21

Image 21

Contents QuickEdit and GigaPulse Addendum Quickedit View Quickedit View Midi Select Edit Modes and SelectionsKeyboard Select DROP-DOWN Menu Edit ModeDimension Select DROP-DOWN Menu GVI General TAB Quickedit Articulation TabsVelocity Response Section Volume Modulation SectionLinear Curve Non-Linear Curve Special Curve GVI AMPLITUDE/PITCH TAB Instrument Global SectionAmplitude Envelope Section AMP Envelope Modulation Section Pitch Envelope SectionAmplitude LFO Section Pitch LFO Section Filter Section GVI Filter TABPage Filter Envelope Section Midi Control Section Filter Envelope Modulation SectionKEY Response Section Filter LFO Section GVI Loop TAB Sample Start SectionLoop Section Waveform View Zoom Tools Quickedit Waveform ViewEnvelope and LFO Selection Waveform Display WindowGigapulse View Opening the Gigapulse UI Gigapulse in the Midi MixerAcoustic Space Section Input SectionMic Group Selection Menu MIC Group SectionPage Page MIC Replacement Section Page GVI Placement Section MIC to FX BUS Routing Section