Pioneer XW-HTD630A manual Additional Information Chapter, Taking care of the unit

Page 13

Additional Information

Chapter 3

Additional Information

Taking care of the unit

Cleaning the unit’s exterior

Don’t...

• Use a polishing cloth or dry cloth to wipe

• Use in a place exposed to high

off dust and dirt. If the surfaces are very

temperatures or humidity, including near

dirty, wipe with a soft cloth dipped in

radiators and other heat-generating

some neutral cleanser diluted five or six

appliances.

times with water and wrung out well,

• Place on a window sill or other place

then wipe again with a dry cloth.

where the unit will be exposed to direct

• Do not use furniture wax or cleaners.

sunlight.

Never use thinners, benzine or

• Use in an excessively dusty or damp

En_XW-HTD630.book13ページ2003年12月26日

金曜日午後1時9分

insecticide sprays or other chemicals on

environment.

or near this unit since they will corrode

• Place directly on top of an amplifier, or

the surfaces.

other component in your stereo system

• If you use a chemical-impregnated

that becomes hot in use.

cleaning cloth, read the instructions

• Use near a television or monitor as you

carefully before use. These cloths may

may experience interference—especially

leave smear marks on half-mirror finish

if the television uses an indoor antenna.

surfaces; if this happens, finish with a dry

• Use in a kitchen or other room where the

cloth.

unit may be exposed to smoke or steam.

• Unplug the unit when cleaning.

• Use on a thick rug or carpet, or cover with

 

Problems with condensation

cloth—this may prevent proper cooling of

Condensation may form inside the unit if it is

the unit.

• Place on an unstable surface, or one that

brought into a warm room from outside, or if

the temperature of the room rises quickly.

is not large enough to support all four of

Although the condensation won’t damage the

the unit’s feet.

unit, it may temporarily impair its

Moving the wireless speaker

performance. For this reason you should

If you need to move the wireless speaker, first

leave it to adjust to the warmer temperature

press POWER on the front panel to turn the

for about an hour before switching on and

unit off. Unplug the power cord.

using.

AC adapter and power cord caution

Hints on installation

• Do not leave the power cord near heating

We want you to enjoy using this unit for years

equipment. The coating of the cord may

to come, so please bear in mind the following

melt, which could lead to fire and/or

points when choosing a suitable location for

electrocution.

it:

• Make sure to grasp the body of the AC

Do...

adapter when removing it from the power

• Use in a well-ventilated room.

outlet. If you pull the power cord, it may

• Place on a solid, flat, level surface, such

become damaged which could lead to

as a table, shelf or stereo rack.

fire and/or electrocution.

• Be sure to switch the wireless speaker off

• Do not attempt to plug in or remove the

when not in use.

AC adapter with wet hands. This may

 

result in electrocution.

03

English

13

En

Image 13
Contents Operating Instructions Mode d’emploi Important Safety Instructions For U.S. model EnglishVentilation For Canadian model For U.S. model Power cord cautionPour le m dèle Canadien Radio wave reflectionsContents Wireless in L/R jacks AC power cable DC in inlet Connecting UpChapter Rear panelWireless in L/R jacks AC power cable Connecting Up Rear panel connectionsSuitable means to reduce the risk of dam XW-HTD630A wireless speaker To power outletFront left Front rightControls and Displays Wireless speakerTransmitter Antenna CH 1 CH 2 CH 3 CHChannel button Turn to adjust the speaker volume when Lights when Auto Auto on mode is selectedWireless Mode is set to Stereo Additional Information Chapter Additional InformationTaking care of the unit Scope of operation Radio wave cautionAdditional Information Troubleshooting Wireless Speaker SpecificationsPower consumption without AC adapter GeneralWe Want You Listening For a Lifetime Additional Information午後1時27分 Ne débranchez la fiche en tirant sur le câble Saisissez le câble d’alimentation par la ficheNe touchez pas le câble avec les mains Mouillées car vous pourriez provoquer unRéflexions des ondes radio Par mesure de sécurité 木曜日午後1時27分Matières Table desContenu de lemballage Chapitre ConnexionsPanneau arrière Émetteur Enceinte sans filConnexions Connexions au panneau arrière Prises Wireless in L/R Cordon dalimentation secteurArrière du récepteur audiovisuel VSX-D414 Même sur une prise secteurSans fil ConnexionsCommandes et afficheurs Chapitre Commandes et afficheursÉmetteur Enceinte sans filSurround ou Stereo Commandes et afficheursTouche Channel AntenneAuto Informations complémentaires Chapitre Informations complémentairesSoin de lappareil Précautions concernant Informations complémentairesLadaptateur secteur et le cordon DalimentationGuide de dépannage Informations complémentaires Caractéristiques techniques Généralités AccessoiresÉmetteur Enceinte sans filPioneer Corporation