Pioneer XW-HTD630A manual English, For U.S. model

Page 3

POWER-CORD PROTECTION — Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product.

LIG NING — For added protection for this

En_XWproduct-HTD630during.book3a lightningページstorm,2003orwhen12月itis6日 left unattended and unused for long periods of

time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.

POWER LINES — An outside antenna system should not be located in the vicinity of overhead p wer lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

OVERLOADING — Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

OBJECT AND LIQUID ENTRY — Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

SERVICING — Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

DAMAGE REQUIRING SERVICE — Unplug this product from the wall outlet and refer servicing

to qualified service personnel under the following conditions:

• When the power-supply cord or plug is damaged.

• If liquid has been spilled, or objects have fallen into the product.

• If the product has been exposed to rain or water.

• If the product does not operate normally by

following曜日午後the1時operating9分instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

If the product has been dropped or damaged in any way.

When the product exhibits a distinct change in performance — this indicates a need for service.

REPLACEMENT PARTS — When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

SAFETY CHECK — Upon completion of any

service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

WALL OR CEILING MOUNTING — The product should not be mounted to a wall or ceiling.

HEAT — The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

English

WARNING: THIS APPARATUS IS NOT WATERPROOF. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE AND DO NOT PUT ANY WATER SOURCE NEAR THIS APPARATUS, SUCH AS VASES, FLOWER POTS, COSMETICS CONTAINERS, MEDICINE BOTTLES, ETC.

[For U.S. model]

IMPORTANT NOTICE

The serial number for this equipment is located on the rear case. Please write this serial number on your enclosed warranty card and keep it in a secure area. This is for your security. H006A_En

WARNING:

Handling the cord on this product or cords associated with accessories sold with the product will expose you to lead, a chemical known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm.

Wash hands after handling

Image 3
Contents Operating Instructions Mode d’emploi Important Safety Instructions For U.S. model EnglishVentilation Radio wave reflections For U.S. model Power cord cautionFor Canadian model Pour le m dèle CanadienContents Rear panel Connecting UpWireless in L/R jacks AC power cable DC in inlet ChapterWireless in L/R jacks AC power cable Connecting Up Rear panel connectionsFront right XW-HTD630A wireless speaker To power outletSuitable means to reduce the risk of dam Front leftWireless speaker Controls and DisplaysTransmitter CH 1 CH 2 CH 3 CH AntennaChannel button Lights when Auto Auto on mode is selected Turn to adjust the speaker volume whenWireless Mode is set to Stereo Additional Information Additional Information ChapterTaking care of the unit Scope of operation Radio wave cautionAdditional Information Troubleshooting General SpecificationsWireless Speaker Power consumption without AC adapterWe Want You Listening For a Lifetime Additional Information午後1時27分 Mouillées car vous pourriez provoquer un Saisissez le câble d’alimentation par la ficheNe débranchez la fiche en tirant sur le câble Ne touchez pas le câble avec les mainsRéflexions des ondes radio Par mesure de sécurité 木曜日午後1時27分Table des MatièresContenu de lemballage Émetteur Enceinte sans fil ConnexionsChapitre Panneau arrièreMême sur une prise secteur Prises Wireless in L/R Cordon dalimentation secteurConnexions Connexions au panneau arrière Arrière du récepteur audiovisuel VSX-D414Sans fil ConnexionsEnceinte sans fil Commandes et afficheursCommandes et afficheurs Chapitre ÉmetteurAntenne Commandes et afficheursSurround ou Stereo Touche ChannelAuto Informations complémentaires Informations complémentaires ChapitreSoin de lappareil Dalimentation Informations complémentairesPrécautions concernant Ladaptateur secteur et le cordonGuide de dépannage Enceinte sans fil Généralités AccessoiresInformations complémentaires Caractéristiques techniques ÉmetteurPioneer Corporation