Operating this unit
Touch to select various setup functions.
4BACK key
Touch to return to the previous display.
5ESC key
Touch to cancel the control mode of func- tions.
1Press A.MENU button to display MENU. MENU appears on the display.
2Touch the desired key to display the function names you want to operate.
# To go to the next group of function names, touch NEXT.
# To return to the previous group of function names, touch PREV.
3Touch ESC to return to the display of each source.
Note
If you do not operate the function within about 30 seconds, the display is automatically returned to the playback display.
The LCD panel will be opened or closed auto- matically with the turning of the ignition switch on or off. You can turn off the automatic close/open function. (Refer to page 42.)
!Do not close the LCD panel with hands by force. That cause malfunction.
!The automatic close/open function will op- erate the display as follows.
—When the ignition switch is turned OFF while the LCD panel is opened, the LCD panel will close after six seconds.
—When the ignition switch is turned ON again (or turned to ACC), the LCD panel will be opened automatically.
—Removing or attaching the front panel will automatically close or open the LCD panel. (Refer to page 10.)
Section
03
! When the ignition switch is turned OFF |
| |
after the LCD panel has been closed, turn- |
| |
ing the ignition switch ON again (or turning | Operating | |
it to ACC) will not open the LCD panel. In | ||
| ||
this case, press OPEN/CLOSE to open the |
| |
LCD panel. |
| |
! When closing the LCD panel, check to |
| |
make sure that it has closed completely. If | this | |
the LCD panel has stopped halfway, leaving | ||
| ||
it like this could result in damage. | unit | |
CAUTION | ||
|
Keep hands and fingers clear of the unit when opening, closing, or adjusting the LCD panel. Be especially cautious of children’s hands and fin- gers.
%Press OPEN/CLOSE to open the LCD panel.
# To close the LCD panel, press OPEN/CLOSE again.
Important
!If you can hear the LCD panel knocking against your vehicle’s console or dashboard, press ANGLE
!When adjusting the LCD panel angle, be sure to press ANGLE
En 15