Pioneer AVH-P4900D Before operating the auto TA and EQ function, Carrying out auto TA and EQ

Page 68

Section

04 Available accessories

Before operating the auto TA and EQ function

!Carry out auto TA and EQ in as quiet a place as possible, with the car engine and air conditioning switched off. Also cut power to car phones or portable telephones in the car, or remove them from the car be- fore carrying out auto TA and EQ. Sounds other than the measurement tone (sur- rounding sounds, engine sound, tele- phones ringing etc.) may prevent correct measurement of the car interior acoustic characteristics.

!Be sure to carry out auto TA and EQ using the supplied microphone. Using another microphone may prevent measurement, or result in incorrect measurement of the car interior acoustic characteristics.

!When front speaker is not connected, auto TA and EQ cannot be carried out.

!When this unit is connected to a power amp with input level control, auto TA and EQ may not be possible if you lower power amp input level. Set the power amp’s input level to the standard position.

!When this unit is connected to a power amp with an LPF, turn off the LPF on the power amp before carrying out auto TA and EQ. In addition, the cut-off frequency for built-in LPF of an active subwoofer should be set to the highest frequency.

!The time alignment value calculated by auto TA and EQ may differ from the actual distance in the following circumstances. However, the distance has been calculated by computer to be the optimum delay to give accurate results for the circum- stances, so please continue to use this value.

When the reflected sound within a vehi- cle is strong and delays occur.

When delays occur for low sounds due to the influence of the LPF on active subwoofers or external amps.

!Auto TA and EQ changes the audio settings as below:

The fader/balance settings return to the center position. (Refer to page 60.)

The equalizer curve switches to FLAT. (Refer to page 65.)

It will be adjusted automatically to high pass filter setting for front, center and rear speaker.

!If you carry out auto TA and EQ when a pre- vious setting of this already exists, the set- ting will be replaced.

Carrying out auto TA and EQ

1Stop the car in a place that is as quiet as possible, close all doors, windows and the sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct auto TA and EQ.

2Fix the supplied microphone in the cen- ter of the headrest of the driver’s seat, fa- cing forward, using the belt (sold separately).

The auto TA and EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat to carry out auto TA and EQ.

3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto TA and EQ.

68 En

Image 68
Contents DVD AV Receiver AVH-P4900DVDEnglish Operation ManualContents Thank you for buying this Pioneer productPrecautions IMPORTANT SAFEGUARDS To ensure safe drivingParking brake interlock 01 PrecautionsTo avoid battery exhaustion Before You Start Information to User For Canadian modelAbout this unit Playable discsAfter-sales service for Pioneer products 02 Before You StartAbout this manual DVD video disc region numbersVisit our website FeaturesBefore You Start About WMA “DTS” and “DTS Digital Out” are registered trademarks of DTS, IncAbout the SAT RADIO READY mark For viewing LCD comfortablyTo protect the LCD screen names and other text information may not be correctly displayedResetting the microprocessor When an operation is prohibitedProtecting your unit from theft Attaching the front panelBefore You Start 03 Operating this unit What’s WhatHead unit k j i h g f e d c b aOptional remote control Power ON/OFFOperating this unit Basic OperationsAdjusting the volume Touch panel key basic operation1 2 3 4 Activating the touch panel keysAdjusting the LCD panel angle Opening and closing the LCD panelChanging the wide screen mode Turning the LCD panel horizontalChanging the picture adjustment Adjusting the dimmer03 Operating this unit Tuner Basic OperationsStoring and recalling broadcast frequencies 1 2 3Storing the strongest broadcast frequencies Tuning in strong signalsIntroduction of advanced tuner operation 03 Operating this unit Built-in DVD player Operating the DVD menu Specifying title Skipping back or forward to another titleOperating the DVD menu with 10 key Changing audio language during playback Multi-audio Changing the subtitle language during playback Multi-subtitlePausing disc playback Changing the viewing angle during playback Multi-angleStopping playback Frame-by-frame playbackSlow motion playback Return to the specified sceneAutomatic playback of DVDs PBC playbackText information Displaying text informationScrolling text information in the display Displaying information on compressed audioPlaying tracks in random order Introduction of advanced operationsRepeating play Scanning tracks of a CD Selecting audio outputResume playback Bookmark 28 EnEntering disc titles Selecting tracks from the track title listUsing balance adjustment 03 Operating this unit Audio AdjustmentsIntroduction of audio adjustments Recalling equalizer curves Using the equalizerAdjusting equalizer curves Adjusting bass and treble Adjusting loudnessUsing subwoofer output Adjusting bassUsing nonfading output Using the high pass filterBoosting the subwoofer level Operating34 En Adjusting source levelsCompensating for equalizer curves EQ-EX Operating this unit Setting up the DVD player Introduction of DVD setup adjustmentsSetting the subtitle language Setting the audio languageSetting the menu language Switching the assist subtitle on or offSetting the angle icon display Setting the aspect ratioChanging the level Setting the parental lockSetting the code number and level If you forget your code number Initial SettingsAdjusting initial settings Switching the warning tone Switching the auxiliary settingSetting the rear output and subwoofer controller Correcting distorted soundSwitching the sound muting/ attenuation Resetting the audio functionsSetting the illumination switch 40 EnIntroduction of setup adjustments Setting the AV inputSetting for rear view camera back up camera Operating this unit Other FunctionsSetting the automatic open function Setting the clockUsing the AUX source Setting the AUX titleSelecting the background display Selecting AUX as the sourceUsing the PGM button 44 EnAvailable accessories XM tuner Switching the XM displayStoring and recalling broadcast stations Available04 Available accessories Switching the XM channel select modeChannel number select setting Channel category select settingAvailable accessories SIRIUS Satellite Radio tuner Switching the SIRIUS displaySelecting the SIRIUS channel select mode Selecting a SIRIUS channel directlyAvailable accessories Playing songs on iPod Pausing a songListening to songs on your iPod Browsing for a song50 En Displaying text information on iPodPlaying songs in a random order shuffle Available accessories Multi-CD Player accessoriesIntroduction of advanced operations 1 Press A.MENU button to display MENU. MENU appears on the displayCreating a playlist with ITS programming Using ITS playlistsFunction and operation Available accessories Playback from your ITS playlistErasing a track from your ITS playlist Erasing a CD from your ITS playlistUsing CD TEXT functions Using compression and bass emphasisDVD Player Displaying disc titlesSelecting a disc Selecting a folderTV tuner 5 Preset list display Shows the preset listStoring the strongest broadcast stations sequentially Introduction of advancedoperations 58 En Digital Signal ProcessorIntroduction of DSP adjustments Using the sound field control Using the position selectorFRONT-L Using the dynamic range control Using the down-mix functionUsing the direct control Using the Dolby Pro Logic04Available accessories Setting the speaker settingCorrecting the subwoofer’s phase Selecting a cross-over frequency64 En Adjusting the speaker output levelsAdjusting the speaker output levels using a test tone Using the time alignment Adjusting the time alignmentAdjusting 3-band parametric equalizer Using the auto-equalizer Auto TA and EQ auto-time alignment and auto-equalizingBefore operating the auto TA and EQ function Carrying out auto TA and EQAvailable accessories Additional Information Troubleshooting SymptomCommon CauseAdditional Information Additional InformationAdditional Information Error messages Understanding auto TA and EQ error messagesAdditional Information Understanding messages InformationMessages TranslationCD-R/CD-RW discs Additional Information Handling guideline of discs and playerDVD discs Read the precautions with CD-R/CD-RW discs before using them Dual DiscsCompressed audio files on the disc Using the display correctly Example of a hierarchyCompressed audio compatibility Handling the displaySmall fluorescent tube Liquid crystal display LCD screenKeeping the display in good condition Additional Information Language code chart for DVD Language code, input codeTerms Additional80 En Additional Information Additional Information Specifications GeneralDisplay AudioFM tuner AM tuner6,.81 IndexAudio language PIONEER CORPORATION 4-1, MEGURO 1-CHOME, MEGURO-KU TOKYO 153-8654, JAPANKSNZF 07A00000 CRB2343-A UC