Available accessories
7Touch band then touch cor dto ad- just the equalizer level.
Each time you touch cor dincreases or de- creases the equalizer level. +06 to
8Touch band then touch cor dto se- lect the desired Q factor.
Each time you touch cor dswitches between the following Q factor:
NARROW
# You can adjust parameters for each band of the other speakers in the same way.
Note
You can select a center frequency for each band. You can change the center frequency in
The
You can turn the
1Touch NEXT twice on the DSP function menu.
2Touch AUTO EQ.
#You cannot use this function if auto TA and EQ has not been carried out.
3Touch ato turn the
# To turn
Section
04
The |
| |
justed for the distance between each speaker |
| |
and the listening position. | Available | |
The | ||
| ||
the car interior acoustic characteristics, and |
| |
then creates the |
| |
on that information. | accessories | |
EQ while driving. When this function measures | ||
WARNING |
| |
To prevent accidents, never carry out auto TA and |
| |
the car interior acoustic characteristics to create |
| |
an |
| |
tone (noise) may be outputted from the speakers. |
|
CAUTION
!Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly be- fore carrying out auto TA and EQ.
—When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.)
—When a speaker is connected to a power amp delivering output higher than the speaker’s maximum input power capabil- ity.
!If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in a drain on battery power. Be sure to place the microphone in the specified loca- tion.
En 67