Fostex manual Usage examples of LM16, Integrating the main unit and control unit

Page 12

Model LM16 [Before using the unit]

Usage examples of LM16

The control unit and main unit of the LM16 are separated. You can set these units flexibly.

<Usage example 1>

Integrating the main unit and control unit.

You can integrate the main unit and con- trol unit.

Use the supplied CAT-5 cable (approx. 50 cm length) to connect between the units. See the next page for details about how to integrate the units.

<Usage example 2>

Mounting the main unit and control unit on the rack.

As shown on the right, you can mount each unit to the rack. In this case, use a CAT-5 cable which has enough length for connecting between the units (the cable supplied with the LM16 is approximately 50 cm length).

<Note>: Use only a CAT-5 STP cable (straight type) for connection between the main unit and the control unit.

<Usage example 3>

Setting the main unit and control unit separately.

You can set the main unit and control unit over a 50 meter distance. In such a case, use a CAT-5 cable which has enough length for connecting between the units (the cable sup- plied with the LM16 is approximately 50 cm length).

<Note>: Use only a CAT-5 STP cable (straight type) for con- nection between the main unit and the control unit.

12

Image 12

Contents Model LM16 Safety Instructions Important Safety Instructions Table of contents Signal flow of the mixer Connecting sources Adjusting the input level Low-cut filter Limiter EqualizerUpgrading the software About power supply Precautions on installationAbout version upgrade IntroductionCleaning the exterior CondensationAbout damage About CAT-5 cableOverview Main features Before using the unit Unpacking the cartonSetting the main unit and control unit separately Usage examples of LM16Integrating the main unit and control unit Mounting the main unit and control unit on the rackIntegrating the control unit and main unit Necessary itemsRack mount adaptor After attaching the adaptor Connecting the power cord Preparation of power supplyConnection to external devices Connection example live stageConnection example home recording MTRBalanced and unbalanced inputs/outputs BalancedNames and functions Control unit input channel 1 through POST/PRE switch Mute switch14 ST/1-2/3-4 assign switches Solo switchControl unit Master channel SUB in jacks / SUB in controlMonitor section Phantom 1-8, 9-16 indicators Internal effects sectionControl section AUX Send controls / Solo switches 24 27 EFF Send control / Solo switchAssign to Stereo OUT switches Output Limiter switchControl unit rear panel Main unit rear panelPhantom 1-8, 9-16 switches Controller connectorGroup OUT 1, 2, 3, 4 connectors Stereo OUT L, R connectorsSignal flow of the mixer Mixer basicsConnecting sources Adjusting the input levelConnecting sources to the input connectors Phantom power supply settingGain adjustment while monitoring EqualizerLow-cut filter LimiterUsing an external effect processor Using AUX 1, 2Pre-fader Post-faderUsing the internal effects processor Using InsertApplying the internal effects Monitoring About the effect typesChannel grouping Solo monitorUsing SUB Set the Source switches on channels 15 and 16 to TRKSet the ST assign switches on channels 15 and 16 to on Block diagram Showing date information Showing version informationR peak indicators R meters between 7Specifications Inputs/OutputsPhysical dimensions Power Consumption approx WGeneral Main unitMMC Command List Midi Implementation Chart Model LM16Declaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Index Effect processorMemo Page Fostex CO