Model LM16 [Names and functions]
Control unit (rear panel)
1
(1) [TO CONTROLLER] connector
Used to connect to the [CONTROLLER] connector of the main unit using the supplied (or a different) CAT5 cable (See page 13 for details).
<Note>: Use only a
Main unit (rear panel)
1
GROUP (+4dBu) | EFF SEND |
| INPUT |
|
|
|
|
|
|
|
AUX SEND | INSERT | INSERT | INSERT | INSERT | INSERT | INSERT | INSERT | INSERT |
R STEREO OUT (+4dBu) L | ST MIX OUT |
USB | MIDI OUT |
CONTROLLER
PHANTOMPOWER
13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
(1) [INPUT (1 through 16)] connectors |
| (3) [AC IN] connector |
|
|
| ||||||
Each connector accepts a mic or line level analog audio signal.
The connector is a combo type - a combined XLR connector and phone jack in one. You can connect a microphone to the XLR connector or connect a line signal to the phone jack. (Note that you cannot use the XLR receptacle and phone jack on a same combo connector simultaneously.) See page 28 for details.
Used to connect the supplied power cord (See page 15 for details).
<Note>: Use only the supplied power cord. A different power cord may cause fire, etc. Also note that when you hear thunder rum- bling, disconnect the power cord from the AC outlet.
(2) [INSERT (1 through 8)] jacks
Each jack is used for connecting an external effects processor such as a compressor/limiter.
To connect an external effects processor, use a
(4) [POWER] switch
Turns on or off the LM16 (See page 15 for details).
<Note>: Do not turn off the LM16 while ac- cessing the internal hard disk. Doing so may destroy data. Even if you turn off the LM16, it consumes a very small amount of power. Therefore, it is recommended to disconnect the power cord from the AC outlet if you do not use the LM16 for a long time.
25