Fostex LM16 manual Forthe US Customers only

Page 43

Model LM16 [Specifications]

FORTHE US CUSTOMERS ONLY

FOSTEX AMERICA LIMITED WARRANTY

The following statement defines specific legal rights. You may also have additional rights depending on the state in which the Fostex product was purchased.

WARRANTY PROTECTION

All Fostex parts are warranted for one (1) year from the date of original purchase, except for recording media, such as hard disc drives and compact flash cards, heads, lamps and fuses, which are warranted, for one hundred-eighty (180) days. Fostex America will repair and / or replace parts during the term of this warranty. Labor costs are also covered by Fostex America for one (1) year from the date of original purchase. Except as specified below, this warranty covers all defects in material and workmanship in this product.

The following are not covered by this warranty:

1.Batteries.

2.Damage to any product that has been altered.

3.Damage to any product on which the original serial number has been defaced, modified or removed.

4.Damage to or deterioration of the external cabinet.

5.Damage occurring during shipment of the product. (NOTE: Shipping claims must be presented to the carrier.)

6.Damage resulting from accident, misuse, abuse or neglect.

7.Damage resulting from failure to perform routine maintenance and / or calibration procedures.

8.Damage resulting from failure to follow instruction in the owner's manual.

9.Damage resulting from repair or attempted repair or by someone other than a Fostex America Service technician or a technician at an authorized Fostex America service station.

10.Damage resulting from causes other than product defects, including lack of technical skill, competence or experience on the part of the user.

11.External appearance items such as cosmetic parts, knobs, liquid crystal displays, buttons, etc.

12.Replacements or repairs necessitated by loss or damages resulting from any cause beyond the control of Fostex America.

13.Damage resulting from misuse or abuse on rental units.

NOTE:

FOSTEX AMERICA IS NOT RESPONSIBLE FOR DATA LOST OR DAMAGED DURING

 

OPERATION OF THIS PRODUCT.

 

CALIBRATION AND MAINTENANCE PROCEDURES ARE NOT COVERED BY THIS

 

WARRANTY.

Fostex America reserves the right to inspect all products submitted pursuant to this warranty.

If such an inspection shows reasonable cause to believe that any of the above exclusions to the above warranty are applicable, then Fostex America or the authorized service station will charge prevailing service rates and parts, costs for any repairs.

43

Image 43
Contents Model LM16 Safety Instructions Important Safety Instructions Table of contents Adjusting the input level Low-cut filter Limiter Equalizer Signal flow of the mixer Connecting sourcesUpgrading the software Introduction About power supplyPrecautions on installation About version upgradeAbout CAT-5 cable Cleaning the exteriorCondensation About damageOverview Main features Unpacking the carton Before using the unitMounting the main unit and control unit on the rack Setting the main unit and control unit separatelyUsage examples of LM16 Integrating the main unit and control unitNecessary items Integrating the control unit and main unitRack mount adaptor After attaching the adaptor Preparation of power supply Connecting the power cordConnection example live stage Connection to external devicesMTR Connection example home recordingBalanced Balanced and unbalanced inputs/outputsNames and functions Control unit input channel 1 through Solo switch POST/PRE switchMute switch 14 ST/1-2/3-4 assign switchesSUB in jacks / SUB in control Control unit Master channelMonitor section Internal effects section Phantom 1-8, 9-16 indicatorsControl section Output Limiter switch AUX Send controls / Solo switches24 27 EFF Send control / Solo switch Assign to Stereo OUT switchesMain unit rear panel Control unit rear panelStereo OUT L, R connectors Phantom 1-8, 9-16 switchesController connector Group OUT 1, 2, 3, 4 connectorsMixer basics Signal flow of the mixerPhantom power supply setting Connecting sourcesAdjusting the input level Connecting sources to the input connectorsLimiter Gain adjustment while monitoringEqualizer Low-cut filterPost-fader Using an external effect processorUsing AUX 1, 2 Pre-faderUsing Insert Using the internal effects processorApplying the internal effects About the effect types MonitoringSolo monitor Channel groupingSet the Source switches on channels 15 and 16 to TRK Using SUBSet the ST assign switches on channels 15 and 16 to on Block diagram Showing version information Showing date informationR meters between 7 R peak indicatorsInputs/Outputs SpecificationsMain unit Physical dimensionsPower Consumption approx W GeneralMMC Command List Model LM16 Midi Implementation ChartDeclaration of EC Directive Forthe US Customers only Fostex America Limited Warranty Shipping Effect processor IndexMemo Page Fostex CO